Question about Jeep Grand Cherokee

1 Answer

HOW TO ADD OIL TO FLOOR JACK? - Grand Cherokee Jeep Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 448 Answers

On the side of the ram you will see in the middle a screw or a rubber plug you might have to lift
arm up and block it with a peace of wood use ether hydraulic oil or auto matic transmission fluid
don't fill it to the top its going to be time consuming but put some in and try it if it doesn't pump to
the top than add more till it works to the top

hope this helps you
bob

Posted on May 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove an oil pan off a 1998 ford 2 wheel drive with out pulling the engine


Remove the bolt that runs thru the engines motor mounts, not the ones that attach it to the engine block. Take a 2x4 and put it on a floor jack so the jack won't damage the front pulley. Raise the engine with the floor jack to get enough clearance to manuver the pan around the steering components once thw oil pan bolts have been removed. Watch the fan blades don't hit the radiator.

Mar 09, 2015 | Ford Cars & Trucks

1 Answer

How can i fix a floor jack it does not go up


that depends did it leak oil out of the shaft seal ? if it did you could add more oil to resavor but that would not be safe as oil will continue to leak out seal and jack will fall down , Most auto parts stores sell hyd jack oil in a can

Sep 22, 2014 | Cars & Trucks

1 Answer

My mechanic tells me my motor mounts need replacing.there are two on top and one underneath. how can i do this by myself


YOU NEED TO SUPPORT THE ENGINE TO REMOVE ENGINE MOUNTS. I USED A LARGE FLOOR JACK WITH A PIECE OF WOOD ON JACK SADDLE.WITH WOOD ON SADDLE PLACE JACK UNDER ENGINE OIL PAN SLIGHTLY RAISE ENGINE WITH FLOOR JACK JUST ENOUGH TO TAKE WEIGHT OFF THE ENGINE MOUNTS THEN REMOVE ENGINE MOUNT.

Jun 27, 2011 | Buick Regal Cars & Trucks

1 Answer

I dont know how to change the drivers side transmission mount on my 99 alero what would be the best way


YOU NEED TO SUPPORT ENGINE TO REMOVE TRANSAXLE BRACE.YOU CAN USE FLOOR JACK WITH A PIECE OF WOOD ON JACK SADDLE.YOU NEED TO REMOVE WHEEL OR TIRE SPLASH SHIELD TO REMOVE THE TRANSAXLE BRACE PLACE FLOOR JACK WITH A PIECE OF WOOD IN JACK SADDLE PLACE JACK UNDER THE ENGINE OIL PAN.SLIGHTLY RAISE JACK A LITTLE JUST ENOUGH TAKE PRESSURE OFF THE TRANSAXLE TO REMOVE TRANSAXLE BRACE.DONT RAISE FLOOR JACK UP TOO MUCH UNDER THE ENGINE OIL PAN BECAUSE YOU COULD DAMAGE OIL PAN AND OIL PUMP.

Jun 25, 2011 | 1999 Oldsmobile Alero

1 Answer

How do u remove the oil pan on a 1994 mustang v6


make sure the vehicle is parked on a flat surface. Jack the vehicle up using a floor jack & jack stands. locate the oil pan underneath the vehicle. drain the oil & remove the bolts from the pan.

Feb 24, 2011 | Ford F-150 Cars & Trucks

2 Answers

Replace serpentine belt


TO REPLACE DRIVE BELT FOR THE 2.0L AND 2.2L ENGINES ROTATE TENSIONER CLOCKWISE USING A WRENCH OR SOCKET USE 19M WRENCH FOR 2.0L ENGINE. USE SIZE 15M WRENCH ON THE 2.2L ENGINE. AND THE 3.1 ENGINE USE A 1/2 INCH BREAKER BAR. IF DRIVE BELT HARD TO GET TO YOU HAVE TO SUPPORT ENGINE WEIGHT USE A HOIST OR FLOOR JACK UNDER THE OIL PAN WITH PIECE WOOD ON JACK SADDLE.SLIGHTLY RAISE FLOOR JACK A LITTLE TO SUPPORT ENGINE TO REMOVE TOP ENGINE MOUNT TO REMOVE DRIVE BELT.DONT DONT OVER JACK ENGINE DAMAGE OIL PAN AND OIL PUMP.JUST RAISE FLOOR JACK SLIGHTLY JUST ENOUGH TO HOLD ENGINE WHEN YOU REMOVE TOP ENGINE MOUNT.

Jan 12, 2011 | 1992 Chevrolet Cavalier

1 Answer

Where is the oil pan and oil filter located?


both on are the bottom of the engine, u must jack the car off the ground to get to them, always use a floor jack and safety stands, never use a bumper jack to get under the car.

Apr 30, 2010 | 2000 Lincoln Continental

1 Answer

Oil and filter change


Jack it up and then put jack stands under the frame. You really need to purchase a good floor jack and 2 jack stands if you wish to change your own oil. This will allow you easy access to the underside. There is only one way to actually change the oil and filter.

Aug 02, 2009 | Audi TT Cars & Trucks

1 Answer

I need to check the oil level.


there is a black rubber plug on the jack bottle(by were the cylinder sits) remove plug add jack oil as needed while the jack is NOT extended or under any weight

Apr 21, 2009 | 1993 Chevrolet K1500

1 Answer

2001 Saturn, need a Serpentine belt diagram


get a floor jack and a small block of wood. place the floor jack under the oil pan. jack up the jack until you feel it on the oil pan. remove the engine mount. you will need a deep 15mm socket and a 6inch extension. the mount has 4 bolts. remove it. then jack the engine up with the floor jack until the power steering reservoir almost touches the cowl. now take a long 14mm wrench and place that on the bolt head on the belt tensioner. pull the wrench until the belt slacks up. remove the belt. Installation opposite of removal. Here is a belt diagram. I hope this helps!! If you have any problems or questions e-mail me at: Redlinetech07@yahoo.com
7744b58.gif

Feb 23, 2009 | 2001 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...