Question about 1990 Nissan Pulsar

1 Answer

Repairing a fuel leak in a nissan pulsar 1990

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

Where is the fuel leak? Depending on it's location, will depend on the procedure needed to perform this repair. Comment back.

Posted on May 22, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1990 n13 pulsar , where is the fuel pump relay

Some Nissans put that relay and 3 others above or on the fuse panel under the dash. Far left one was the Accessory relay, then the Ignition relay, next was the ECCS relay (the ecu relay), and last on the right was the fuel pump relay, if I recall correctly. I'm pretty sure everyone was exact same relay, same part number. I also believe the fuel pump fuse was in that fuse panel.

Sep 26, 2015 | 1990 Nissan Pulsar

2 Answers

1996 nissan pulsar

Secondary ignition. Plugs./ Wire

Jan 02, 2018 | 1990 Nissan Pulsar

1 Answer

How do you fit a timing belt for a nissan pulsar 1990, were are the bolts to loosen the chain?

May 01, 2010 | 1990 Nissan Pulsar

1 Answer

How do i get to the fuel pump in a nissan pulsar vector? i turn the car over and the fuel is pooring out somewhere above the fuel tank....thnkz

Hi there,

The fuel pump is mounted "inside" the fuel tank. You'll need to remove the rear seat (bottom portion) to gain access to the pump assembly.

If fuel is pouring out, then there is an obvious leak from either the hoses (attached to the fuel pump) or from the pump seal in the tank.

Here is the diagram:


Hope this helps...

** If the has helped you in any way, please rate this solution **

Nov 14, 2009 | 1990 Nissan Pulsar

2 Answers

Hi, my 2004 nissan pulsar is overheating. has a new thermostat and radiator cap. mechanics did a pressure test and said it was fine, no leaks that we can see, and no blown head gasket evident. please help.

Is the thermostat put in correctly?Can you see coolant circulating w/ rad cap off.Start cold w/ cap off and as the coolant heats up you should see flow

Jul 07, 2009 | 1990 Nissan Pulsar

1 Answer

I have a 1993 nissan pulsar N14, I would like to replace the fuel filter. Where would I be able to find this? Any help would be greatly appreciated.

you may possibly find it under the car, back near the fuel tank, if you follow the fuel line out of the tank it should be reasonably close to the tank.
Have not had anything to do with pulsars but a lot of the modern cars have their fuel filters in a similar position

Jun 15, 2009 | 1990 Nissan Pulsar

Not finding what you are looking for?

Open Questions:

See all 1990 Nissan Pulsar Questions

1990 Nissan Pulsar Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

80668 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides