Question about Mitsubishi Eclipse

2 Answers

I have a 95 eclipse 2.0L nonturbo...the car will shift thru all the gears but wont move.....what could cause this?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 14,036 Answers

MANUAL SHIFT VALVE LINKAGE BROKEN OR DISCONNECTED.OR TRANSMISSION FLUID LEVEL TOO LOW TRANSMISSION SLIPPING,TRANSMISSION FLUID OLD DIRTY BURNT AND TRANSMISSION FILTER STOPPED UP COMPLETELY.INTERNAL TRANSMISSION FAILURE.

Posted on May 22, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 324 Answers

If it is a standard transmission then it sounds as if the clutch and possibly pressure plate need replacing or adjusting. if it is an automatic then it sounds like it has gone out.

if a clunking noise is heard then it could be the cv joints or shafts .

sorry I couldn't clear it up more

hope this helps.

Posted on May 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission on 95 blazer shifted until installed now wont pull into gear..why


Is this true even when engine not running? If so, trans input shaft must not have gone into pilot bushing correctly, or clutch disk jammed it. suggest loosening trans bolts to see if it moves back as you do. Otherwise, shifter installed incorrectly. Stick shift, true?

Feb 26, 2015 | Cars & Trucks

1 Answer

1999 mitsubishi eclipse automatic transmission wont shift into 4th gear.


First off.. If you have a check engine light on, Find someone with an OBD2 READER or buy one yourself(very good tool to have) and that will give you the code(s) to your problem..

If not.. Check ALL your fuses..

If those are good and you DO NOT have a sealed tranny.. Check your fluid..

If all the above check out good.. It's gonna be 1 of 2 things..

1. Your overdrive is either turned off and/or damaged.. (Over drive on: uses all 4 gears/Over drive off: uses only 3 gears)

2. Your shift silonoid pack is damaged, which normally when this happens your car goes into a thing called "dummy mode" and keeps the tranny ONLY in 2nd gear..

Now assuming your car shifts into every other gear just fine.. And the fact that normally reverse is the first gear to go out.. I'm gonna say it's your overdrive or a relay that runs with your overdrive..

Let me know what happens or if you have anymore questions..


-Daniel
Proud Owner of the
sickest 97 eclipse.

Sep 28, 2014 | 1999 Mitsubishi Eclipse

3 Answers

95 eagle talon esi automatic wont shift up out of 2nd gear


a bad coolanant temp censor will keep one from shifting into upper gears you need to run the codes on car an see what it says is wrong with it

Aug 01, 2010 | 1995 Eagle Talon

1 Answer

Transmission wont shift into any gear


if you can shift gears with car off might be the clutch or slave cylinder. If you can start the car in gear,clutch pushed in and doesnt try take off probally not slave cylinder. But if it tries to take off,slave cylinder. Now if it doesnt try to take off,ease clutch out. Does it move or just rev up? If it revs up likely the tranny. But if it moves can you shift thru all gears,if so clutch is shot.

Feb 27, 2010 | 1995 Toyota Camry

1 Answer

It wont go into gear but the gear shift moves on a 95 buick reviera.....So whats the Problem?


Sounds like the linkage has gotten loose from transmission. If not then something is broken in transmission. Is shifting feel normal or very loose?

Feb 24, 2010 | 1995 Buick Riviera

1 Answer

Wont move


well the first thing is to make sure it has enough trany oil in it. if it does then you may have a bad trany.hope this helps.

Jan 27, 2010 | 1999 Mitsubishi Eclipse

2 Answers

I own a 2004 mitsubishi eclipse


There is a cable that goes from the gear shifter to the ignition switch that keeps the key in place until it is placed in park. The cable needs to be lubracated and has to much friction to operate correctly. The consoled has to be removed to correct this problem. Locate the small cable and lubricate it.

Sep 22, 2009 | Cars & Trucks

1 Answer

Car wont drive in gear


are your cv shafts still in tact? if so then your trannsmission needs to be serviced

Apr 25, 2009 | 1996 Mitsubishi Eclipse

1 Answer

Doesnt sound or feel like my cars shifting AUTO Transmission


Have You Checked Your Transmission Fluid?
Or Even Change It That Always Makes A Work Of Difference.

Jan 06, 2009 | 1990 Nissan 300ZX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...