Question about 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Engine has miss at low rpm. Noise coming from front of motor. Removed the belt noise still there. could it be an injector? No engine light

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 3,640 Answers

Use a piece of hose, and put your ear to it. if it is an injector, you can tell. or a mechanics stethascope. have a good day !! you can also use a long screwdriver, and put ear to handle and touch to injector, to see if its working.

Posted on May 22, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Click coming from timing chain x type 2.0 jaguar


if the noise is definately from the front engine timing chain cover area then the first thing i would do is remove the auxillary drive belt/fan belt then start the engine to see if noise is still there? if so the only option is to remove the front engine cover and from remember you may have to remove the cylinder heads also, even remove engine for access\,big job, the engine is normally a bullet proof unit, if the oil has been changed at service advised intervals then the hydraulic chain tensoiner etc should be ok and most noise problems at the front of engine area are caused by. ie. belt tensioner, air con compressor,pas pump etc. so if noise goes when aux belt removed look at the that area. hope this helps.

Jul 31, 2016 | Jaguar X-Type Cars & Trucks

1 Answer

F22a engine produces strange noise most obvious at 2000 rpm, what could the problem be?


Without a general description of what the noice sounds like, squeal as compared to knocking, it is impossible to help you. Engines make a lot of different noises, so try and help by describing noise. I would suspect it is belt related, or tension pulley related as these are RPM variable noises, belts tend to slip when you accelerate and can be quite loud with a serpentine belt as example.
CERACOAT-NANOTECH.com

May 14, 2015 | 1996 Honda Accord

1 Answer

Bad oil pump ?


Turn your A/C off, the compressor can make noise if bearings are dry or system is low on compressor oil.
Remove your serpentine belt. Turn pulleys by hand to check for roughness. Bearings in those pulleys routinely go bad.
You may get computer warnings with the following test, but with serpentine belt removed, run engine for 2 or 3 minutes. Do this on a warm engine after serpentine belt is removed. The warm oil will not mask the problem like cold thick oil can. Noise generated means problem is internal.
If this is a stick shift transmission sometimes the clutch bearing can make noise and is a sign that bearing is bad.

May 13, 2013 | Ford Focus Cars & Trucks

1 Answer

Noise from engine front end


it is always good practice to replace idler pulleys , seals , hydraulic adjuster when replacing a timing belt as the everything is worn out as well
It is now possible that the idler bearings for the belt are failing
If the pulleys , crank and cam seals and hydraulic adjuster were all not replaced with the belt then they job will have to be done soon

Nov 06, 2017 | Cars & Trucks

1 Answer

I had the same problem also on my 1994 previa supercharge


u mean is knocking noise?
i think it came from the shaft in front of engine that drives the accesories pully in front. when the a/c is running or the rpm rise up a bit, the noise is gone. try go under the vehicle and spot where the noise come from. as i know is come from the shaft in front of the engine. the coupling need to be replace.

Jul 22, 2009 | 1995 Toyota Previa

2 Answers

2003 Nissan Altima, Air condition makes loud noise when the unit is turn on. It slows down where u cant almost hear it after you turn the fan off.


When you put your A/C on, there is Vacum Motor or Solonoide, that increases RPM of the Engine to compensate the load of an A/C. If the vacum hose is leaking or raptured the RPM of Engine remain low and Engine Shakes. When you put the A/C on and the RPM of Engine Increases, but a little, then your Selonoide is working but not adjusted properly, so adjust it for the proper RPM of the Engine. Put all the loads on, I mean Head Lights and A/C on and then ajust the RPM.

Jun 02, 2009 | 2001 Nissan Altima

1 Answer

Rattling Coming from Engine At low RPM (stopped) and when accl.


If this sounds like a tin can rattle it is likely a loose heat shield on top of the catalytic converter. They come loose after time and corrosion take their toll.

Feb 25, 2009 | 2001 Lexus Gs 300

2 Answers

Noise from front of motor


Yes the idler pulley can make noise, but not very common. It can do it though.

Jul 24, 2008 | 2003 Ford F150 Regular Cab

Not finding what you are looking for?
2007 Dodge Caliber SXT Sport Hatchback Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...