Question about 2007 GMC Yukon XL Denali

1 Answer

How do i change out the battery on my 2007 denali. what is keeping it locked into position

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 87 Answers

There is usually a small bolt that holds it in place with a rubber block the rubs along the bottom of the battery. Take a flash light and look for the small bolt at the base of the battery,,You need like a 1/4" drive socket with a 6-9" extention on the socket to reach it..Just unscrew the bolt and the bolt and the block will come loose,you just lift it up and out of the way. Remove old battery and reinstall new one in reverse order.

Posted on May 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 GMC Yukon Denali occasionally will not start. It will just click or nothing at all. There are no codes being registered, the battery has been changed and cables checked and a new starter has been...


{: ) I wonder how the cables were checked. Did it pass the 200mv voltage drop limit for the negative and positive cables? And do you happen to observe other disturbing symptoms while driving?
You can also try swapping your starter relay (at the underhood fujseblock) with a similar one, also check the relays corresponding terminals on the fuseblock for proper tension. The fuseblock terminals may have loose contacts withe the starter relay.
As for the warranty, it depends on your sales details witn your dealer. Normally a 2007 model is already out of warranty.

Jul 06, 2011 | 2007 GMC Yukon XL Denali

1 Answer

2007 Yukon Denali...have removed the brackets but we are not able to lift out the battery to change. What else is holdong the battery down?


look at the bottom ridge of the battery case, there is usually a small plastic clamp/ bar with a 10-13 mm bolt holding the battery in place with a hold down clip/ bar on the other side of the battery.

Apr 17, 2011 | 2007 GMC Yukon Denali

1 Answer

Yes i have a 2007 gmc yukon denali. when i bought it they didnt give me the keyless entry pad with remote start, then when they did give me one it wasnt the one for my vehicle, they told me all i had to do...


Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the DOOR unlock switch.
While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds , the doors will lock and unlock to confirm the programming of that transmitter.
Repeat the previous step to program up to four transmitters.
Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation

Feb 11, 2011 | 2007 GMC Yukon Denali

1 Answer

2007 gmc yukon denali wont unlock w/ keyfob


Check the buttons.. I have an 06 Grand Prix with the Remote starter on the top and it seems that the conductor on the buttons worn out.. Take the keyfob apart, pull the rubber buttons off the chip, lick your finger and touch the place where the unlock (right side of the fob) would be. That should unlock your doors. I just did it with mine. I would just buy another fob on ebay and change the buttons out.. Hope this works

Apr 23, 2010 | 2007 GMC Yukon Denali

1 Answer

How can you set up a secondary battery on 2007 Denali


carry a battery booster pack. they are like 50 bucks. Any eletrical modification you do to your vehicle and its not done by a gmc dealer, your eletrical (and possibly other) parts of your warranty will be voided. If you keep the booster pack charged, all you have to do is hook it to the terminals and your going again. You can also buy a bigger battery. Im sure they battery is already a monster, buy shop around and see if you can get a bigger (amps) one that fits your truck

Dec 08, 2009 | 2007 GMC Yukon XL Denali

1 Answer

Want to know if i can put a differential from a 2007 tahoe on mi 2003 denali xl mine is lock


Look in the glove box and look at the GM PRO Code sticker. Look for the codes GU1=axle ratio 2.41 GU2=ratio 2.73 ect up to GU6=ratio 3.42 or it may be GV which is the rear axle ratio codes. As long as the codes on the Tahoe matched the Denali your good to go. Good luck and keep me posted, If you'll like me to let you know your rear axle ratio and if it's a locking or not just ask, be glad to help

Jun 09, 2009 | 2003 GMC Yukon Denali

Not finding what you are looking for?
2007 GMC Yukon XL Denali Logo

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...