Question about 1988 Chevrolet S-10

1 Answer

Electrical problem when lights are on , engine cuts out , had alt.checked & good , batt good&

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,252 Answers

Check for a lose ground on engine block...

Posted on May 21, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 chevy malibu my alt isnt charging new alt batt test good cut out the fuselink on starter the alt wire runs thru firewall If i run a wire straight to the batt it is putting out 19v any suggestions


Did you check the fuse in the under hood fuse box ? GEN / BATT fuse 10amp . Is your check engine light on ? This is a computer controlled charging system , it should have four wires connected to the alternator . 1 - the heavier wire on the back ,this comes fro the starter - the one with fusible link , you could have checked for battery voltage with voltmeter ! The three other wires in the connector are the orange one ,this comes from the GEN / BATT fuse an should have battery voltage ! The last two come from the PCM - engine computer . The gray wire is the turn on signal from the PCM an the Red wire is the control from PCM ! Charging System Wiring Diagram MOTOR Magazine Article MOTOR Information Systems

Aug 14, 2015 | Cars & Trucks

1 Answer

Bad pcm symptoms


Have you checked to see if it is charging when the lite is on? I would change the alt the brush's get uneven and warn and decide to charge when they want to.

Nov 12, 2013 | Cars & Trucks

1 Answer

The car died lights went dim then engine cut out with the key on there is no batt light on the dash. I unpluged the 2 wire conector at the alt and started the car after I charged the batt. still no batt...


sounds like you either have a loose wire that is preventing the alternator from charging the battery and keeping you going or the alternator has a bad diode. Take it to an auto parts store and have them test both battery and alt while the car is running.

Feb 07, 2011 | Kia Sephia Cars & Trucks

1 Answer

Battery not charging. had alt tested and it checked out. batt is brand new only a few hours old. was driving and tranny started shifting up and down, lights on gauges went out, no tail lights. connections...


check the big wire that goes to the fuse box under the hood. there is one that goes from the batery across the radiator shroud. then them. also check the ground from the engine block to the firewall its flat with no coating.

Nov 18, 2010 | 1993 Chevrolet Suburban

1 Answer

Alternator is not charging the battery. The battery has been tested & will hold a charge. The alternator has been tested and is also good putting out 75 amps. I've checked the connections, all appear...


thats not always a great way to diagnose alternator problems if you have alot of electrical components on your vehicle the alt will not run the vehicle,also the alt. is not going to charge your batt. its job is to maintain your batteries life, if you do not have a load tester to test your batt. have some one at a autoparts help you most are free of charge to check.. goodluck

Mar 10, 2010 | 1989 Ford F 150

2 Answers

Low or bad voltage i replaced the alt and batt is good dash gauges are not working check engine light was on before the issue and dont come on now.will run if i jump the batt but then just drains.not...


are you sure the alt. is good 
how long does it take to drain down
have the alt rechecked by auto store they do it for free 
does it die even if its running meaning you are just using the life of the battery then it dies then its your alt.

poormansdvd@yahoo.com if you need further trouble shooting

Mar 10, 2010 | Mazda B4000 Cars & Trucks

1 Answer

My 2000 Hyundai elantra and all the gauges, radio, etc quit and


your charging system is not working,so your car is working only on batt. power,when batt.gets weak car will cut off! good chance alter nator is defective! check alt.elect. connections at alt,if con.are good its alt.

Apr 19, 2009 | 2001 Hyundai Accent

1 Answer

Eating alternators mitsubishi shogun 1994 2.5td gls


is your a 12v or 24v some imports are 24v and engine parts are different thanks brian

Mar 07, 2009 | 1988 Mitsubishi Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...