Question about 2006 Nissan Titan

2 Answers

Front end shake when braking no recalls - 2006 Nissan Titan

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Nissan Master
  • 705 Answers

Nissan has a TSB for your brakes. If your truck has less than 36000 on it, they will replace the front rotors and pads and resurface the rear rotors and install new pads. Common problem on a Titan and Armada. 3years or 36000 mile coverage.

Posted on Aug 16, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 255 Answers

Hi..it is usual for lots of cars to shake while breaking do to warp rotors caused by heat when braing ,have them resurface and I allmost certain that this will fix your problem... good luck)(

Posted on Aug 15, 2008

2 Suggested Answers

  • 4 Answers

SOURCE: front end shakes at all speeds, worsens at higher

Hello!
Could honestly be something a simple as low air in one of the front tires that will throw off alignment, or a little more complex as a bent tie rod or worn out CV joint (low on lube). Start with the simple -- check the air in all the tires and make sure they are all at the correct PSI. If you still find that it does the same, try driving it on the highway (or any straight away) and let go of the wheel for a brief moment to see if the car pulls to a certain direction. If it still drives straight then I would scratch off the bent tie rod. Still could be CV joint or even the sway bar is damaged. Being a 2003, I may even venture to say that the engine mounts may be a little worn and the shake is the result of normal engine running but poor stability due to the old mounts.
As you can see there could be a WIDE range of things. Best thing to do for safety sake is to bring it in to a shop. Have them do an inspection. Most places charge minimal for an inspection and at that point you can make a decision on whether it is worth fixing.
Hope this helps a little!

Jeff

Posted on Jul 25, 2010

vondell8
  • 74 Answers

SOURCE: WILL A PROBLEM WITH FRONT STRUT CAUSE THE FRONT

I'm out from under a hood for a few seconds right row, and don't have time to look it up, but I would say yes, it could be as you believe, but also have your wheel bearings checked. They could be worn, dry or damaged. Also, I believe that SUV comes in both 2WD and 4WD. Which model do you have?

Posted on Oct 26, 2011

Testimonial: "yea thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When braking, car violently shakes and and awful noise coming from front end.


the front brake disc is waving , out of end play ,,change front disc and you solve the problem
hope it helps

Mar 27, 2014 | 1998 Chevrolet Cavalier

2 Answers

2005 jeep cherokee front end pulsating


Please have this checked out as soon as possible. Either you, a Mechanic, or an alignment shop, need to check out the front-end and all four points. Something has changed, broke, or is loose and worn out. Check: Ball-joints, wheel bearings, tie-rods, rims, lug-nuts, tires, tire balance, tire inflation, tire tread wear, alignment, U-joints, shocks, and suspension. Let me know if I can be anymore help, good luck.

Mar 07, 2014 | 2005 Jeep Grand Cherokee

1 Answer

What makes a front end shake on a 2004 GMC Sierra 1500 4X4?


FRONT END SHIMMY AND SHAKING COULD HAVE A TIRE OUT OF BALANCELOOSE OR WORN WHEEL BEARINGS, WORN OUT BALL JOINTS,WORN OUT TIE ROD ENDS, FRONT END NEED ALIGNMENT.BRAKE ROTOR WORN OUT OR WARPED, MANY THINGS WILL CAUSE FRONT END TO SHAKE SHIMMY.

Aug 09, 2011 | 2004 GMC Sierra 1500 Crew Cab

2 Answers

My 93 lebaron 4 door has a shake int the front end and all the ball joints, tie rod ends, control arm bushings, and cv shafts are tight.


Does it pull to one side? Could possible be warped rotors, or a bad caliper.

Does it shake all the time even when braking, or only when braking? High speed or low?

May 02, 2011 | 1993 Chrysler Lebaron

2 Answers

Front end shakes when braking


will try to help. when front wheels shake while applying brakes and you can feel shake in steering wheel, front brakes and rotors need replacement.rotors are warped,if you replace front brake pads, it will return[shaking when you apply brakes] suggest that you replace front rotors[both] replace [both]front brake pads. cost? i would charge [brake pads cost $55.00] labor,$60.00] total $115.00 thank you for choosing fixya.com

Dec 04, 2010 | 1998 Ford Windstar

1 Answer

When i drive it it shakes really bad it has new tires and have hade them balensed severl times


The front end of the vehicle has several parts that cause the front end to shake. Have you had the front end checked for bad tie rod ends, That is the most common problem.Another thing when does it shake? If it shakes while applying the brakes it could be the rotors need to be turned or it could be both the tie rod ends or the rotors.

Feb 12, 2010 | 1997 Ford Expedition

1 Answer

Antilock break acting funny. front end shakes


Rust under the front wheel speed sensors causes them to lift up sending a false speed reading to the brake controller. This has been a problem for quite some time. GM has a safety campaign recall for this problem. Call a dealer tell them about your problem and ask them to run your vin number to find out if it is covered by the recall. If its not covered you can fix it yourself.

Remove the front brake rotor, the sensor is behind it. Carefully twist the sensor while pulling upward on it. There will possibly be a rust ring above the o-ring on the sensor that will cause the sensor to break. After the sensor is removed cover the hole and remove the rust to the point of bare metal, clean the area, spray a non-corrosive primer on the area, wait for it to dry, use a heavy grease on the sensor and the mounting area. Reinstall the sensor and the brake parts.

Dec 12, 2009 | Chevrolet 3500 Cars & Trucks

2 Answers

Wheel shaking?


There are many things that can cause front end vibrations, I will give you a list and hopefully the information provided will allow you to narrow it down. Usaully front end shake is caused by a tire that either has a shifted belt in the tire or the tire weights could have falled off and the tire and wheel must be rebalanced, another reason for shake is if the shake occurs when applying the brakes it is a warped rotor and the brakes must be replace in the front end along with new rotor installed, the last thing that it could be is a loose or worn out front end part perhaps a tierod end. If i was you I would try rotating the tires from the front to the back and see if the shaking goes away if it does it is most likely a bad tire (shifted belt) or the tire needs to be rebalanced at a auto garage. after checking that first then jack up the front and grab the wheel and move it back and forth up the down to check for play or loosness, as I said if the shaking occurs while applying the brakes replace the brakes and rotors.

Oct 13, 2009 | 1990 Ford Thunderbird

3 Answers

Front end shakes bad when I brake


My dear if according to you,

You've replaced tie rod ends, lower ball joints, sway bar links, struts and strut ends, and the warped brake rotors and the issue is still at hand; then you ought to consider replacing the hubs.

Good luck.

Jul 29, 2009 | 1996 Ford Taurus

Not finding what you are looking for?
2006 Nissan Titan Logo

Related Topics:

434 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...