Question about 2008 Dodge Nitro

Open Question

2008 Dodge Nitro, the center brake light works but the right and left do not. the directional work and the parking lights work, have not found a fuse that looks blown any suggestions

Posted by on

  • bob c May 21, 2011

    Are the turn signals and the brake light the same bulb?

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 740 Answers

SOURCE: Left and right brake light doesn't work but center lights does

check behind the brake peadle for a little button that pushes in and out when the peadle is pressed(this is your brake light switch) some cars have more than one of theese. manualy let the button out if the light works the switch is good if it does not disconect the harness from the switch and take a small piece of wire and jump the two prongs on the harness if the brake lights come on then you need a brake light switch. if this doesnt work check for power at the switch. if no power you have a bad fuse if there is power and you already jumped the wires to the switch then you have a broken wire between the switch and the tail lights.

Posted on Jan 01, 2010

Ad
emissionwiz
  • 76691 Answers

SOURCE: Steps on how to change oil filter on 2008 Dodge Nitro

unscrew the old filter, lube the rubber O ring seal of the new one with engine oil and install, tighten 3/4 of a turn from when it contacts sealing surface of engine.

Posted on Mar 05, 2009

  • 202 Answers

SOURCE: emergency brake light comes on while driving

The wire that connects to emergency brake is loose, and grounding out. It probably just needs to be tightened up.

Posted on May 27, 2009

  • 113 Answers

SOURCE: where is the oil filter located on my 2008 dodge

You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

Posted on Mar 13, 2010

  • 645 Answers

SOURCE: left and right rear brake lights are out. center

it sounds like you need to replace the turn signal switch ( also known as a multifunction switch). The brake lights also go through that switch; You will have to remove the cover from around the lower part of the steering column to gain access to the switch.Hope this helps. Please leave comment.

Posted on Mar 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My DODGE NITRO 2008 RT, will not shift out of park. what to do?


Will the shifter move out of park? If not the cable or linkage is stuck. If shifter moves but car doesn't and engine revs. Transmission is slipping and needs repair. If possible have scanned and get code

May 02, 2016 | 2008 Dodge Nitro

1 Answer

When I press the brake pedal only the left brake light comes on. The bulbs are good and the fuses are all good. Replace the right light modual but still no help. this is on a 2008 Dodge Nitro


How do you know the bulb is good? Even if it uses the same bulb as the tail light it is always a different filiment. But if you tried replacing the bulb and the fuse than it has to be the wiring. If it's a 2008 it should be covered by the warranty, I would bring it into the dealer.

Aug 17, 2011 | 2008 Dodge Nitro

3 Answers

Where is the fog lamp switch on a 2008 dodge nitro? I have fog lamps but I can't seem to turn them on, am I missing something here?


you need to turn on your park lamps, then the same switch pulls out on the end turning the fog lamps on

Jan 23, 2011 | 2008 Dodge Nitro

1 Answer

2008 dodge nitro change oil light how to turn off had oil changed did not go out


Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.

May 21, 2010 | 2008 Dodge Nitro

1 Answer

Parking brake light comes on intermittently


Check the switch on the emergency brake lever.

May 27, 2009 | 2008 Dodge Nitro

1 Answer

Emergency brake light comes on while driving


The wire that connects to emergency brake is loose, and grounding out. It probably just needs to be tightened up.

May 27, 2009 | 2008 Dodge Nitro

1 Answer

Trying to replace driver side parking light on dodge nitro


You will need a flat blade screwdriver and a T20  torx Open the tailgate, on the inside of the lamp cluster there are 2 plastic domed heads that look like blanking plugs, with a flat bladed screwdriver pry them out, then grasp the lamp unit and pull it backwards, the 2 balls need to pop out of the plastic sockets and you will have the unit in your hand, on the back of the lamp the bulbholder is held in with 2 T20 torx screws, undo these and pry the holder out of the lamp, get someone to operate the lights and indicators to work out the faulty bulb, re-assemble in reverse order, pat the lamp into the panel with your hand.

Apr 05, 2009 | 2008 Dodge Nitro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...