Question about Chevrolet Impala

1 Answer

Took bolts off rear tires on my impala 2009 and tires wont come off

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 110 Answers

The rims may be corroded onto the hub or brake drum. I recently had this problem and used a rubber mallet to loosen the rim. After you get them off, use an anti-corrosive on the back of the rim to prevent a reoccurance.

Posted on May 21, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear end vibration in 2009 chev. impala


check the rear sway bar bushings or trailing arm bushings....here is a pic for reference...
25419100-0zrxxgbhqjc0e4fyjnl1mtlv-2-0.jpg

Feb 12, 2015 | 2009 Chevrolet Impala

1 Answer

2009 chev impala rear wheel hub


2009 chev impala, what is torque on front hubs

Aug 23, 2012 | 2009 Chevrolet Impala LS

1 Answer

2003 impala rear of car kicks out around turns feels like car is dog tracking but coil springs look okay


Look for loose parts, loose front carriage bolts, suspension bolts or wear, and don't forget to make sure that tires are all the same size and that the wheel bearing are all good. This can be a difficult thing to find, but these are good places to start.

Oct 26, 2011 | 2003 Chevrolet Impala

1 Answer

How to I get the low tire pressure light and message to go off on my 2009 chevrolet impala after I air my tire to the correct tire pressure?


It should go off automatically after driving the vehicle.

The proper tire inflation for your vehicle will be on a sticker located inside the driver door opening.

If it does not you will need to have the sensors checked to see if they are reading the correct pressure. This will need to be done with either a scan tool capable of reading TPMS data or with a TPMS sensor scanner.

May 03, 2011 | 2009 Chevrolet Impala

1 Answer

I put air into my two front tires last night. THen my "check right rear tire pressure message comes on when I start the vehicle and the pressure reads 53 lbs even though a manual rire gauge shows 32...


Two things, first try another tire guage, second the sensor is bad. these can cost up to $80.00.
Replace the sensor or ignore the light and keep check on the tire pressure.
Randy

Nov 09, 2010 | 2009 Chevrolet Impala

1 Answer

What is the correct tire pressure for a 2009 Chevy Impala with Goodyear tires? was not on my papers


Look at the inside of the drivers front door. There will be a tire pressure inflation sticker. I do believe 30psi is normal for most newer GM "full size" cars.

Sep 26, 2010 | 2009 Chevrolet Impala

1 Answer

How do I reset the Tire Pressure Light on a 2009 Impala. The Radio does not have a DISP button. I have also tried using the light switch with no luck.


There are transmitters on each of your tires at the valve stem. You need to take your car to a tire shop. They have a hand held scanner that can reset your transmitters.

Aug 14, 2010 | 2009 Chevrolet Impala

1 Answer

Going over bumps the rear end slides sideways . Feels like the car will slide out of control over small numerous bumps. had old tires on the rear at first and thought that was the problem but have new...


First guess is bad shock absorbers. You may have a broken or disconnected 'track bar' that locates the rear axle laterally. Make sure that both spring assemblies are intact and nothing is loose. Check the control arms for damage and for loose or damaged bushings or bolts. Check the rear tire treads for abnormal wear indicating alignment problems.

Nov 11, 2009 | 2004 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...