Question about 1993 Isuzu Rodeo

Open Question

Isuzu 2.6lt 1993 rodeo. where is the coolant temp sensor located on the engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Ford 460 Engine Temp sensor

looking at  the  front of  the engine, just to  the right and behind  the  distributor cap. You  will  see a  wire attached (push on).

Posted on Aug 24, 2008

  • 3 Answers

SOURCE: 1993 Isuzu Rodeo engine tick

a very common problem with these engines is a clicking sound in the engine, it can be a slight annoying click, to a loud knocking sound. I end result is usually the same, replace your timing belt and tensioner. I researched this problem when i bought mine, and it was knocking. i replaced the timing belt, (which was loose) and actually took the tensioner apart and cleaned it (not recommended for the mechanically challenged). new tensioners may be tought to find. when i put it all back together, it ran smooth and quiet.

Posted on Sep 05, 2008

honeymokey
  • 3113 Answers

SOURCE: Isuzu rodeo leaking coolant from engine

V6? If it is the water pump, the timing belt and tensioner should be replaced too. The timing belt operates the water pump and has to come off. A LOT more than four bolts! Get it pressure checked. Sometimes the leak maybe a small coolant hose leaking and running down the front of engine, like throttle body coolant hose or an oil coolant hose on this suv.

Posted on Apr 27, 2009

  • 1 Answer

SOURCE: My Isuzu Rodeo O2 sensor light is on and I would

There's also a circuit on the back of the instrument panel that causes the O2 lamp to light every so many miles- I guess its a way to remind you to change the sensor. To re-set the O2 warning circuit, you must remove the instrument panel and locate a set screw on the back of the green circuit board. Remove the screw from the receptacle it's in and relocate it to the receptacle next to it. This will re-set the warning light.

Posted on Jun 06, 2009

  • 6 Answers

SOURCE: Were is my ABS sensor located on my 2000 Isuzu Rodeo

there should be a sensor at all 4 wheels so make sure there all pluged in 

Posted on Jul 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolant temp sensor location on 1998 Isuzu Amigo 2.2L 4X4.


Go in on utube and ask the question Where is the 1998 Isuzu amigo coolant temp sensor located good luck

Oct 22, 2014 | 1998 Isuzu Amigo

2 Answers

Where is the obd port on my 1993 isuzu Amigo


wow no engine size stated, and MATTERs.!
with no tech1 or 1a scan tooL (real scan tools)
what good is DLC?>
sure jumper CODES< (DTC errors in todays parlance)
there is abs tool.. but only on some cars.

and more. read the FSM yet?
lets pretend you said how do i get the PCM flash error codes
easy jumper the DLC. 'diag, link connector"

google Isuzu DLC jumpers, nets you all this.

http://www.troublecodes.net/isuzu/

there is no world standards for OBD1 so DCL are
every freakn where.

in cab or engine bay or like hondas, on PCM casiing
wild and wolly DLC>


quote

Multi-Port Fuel Injection

Amigo,Trooper II , Rodeo & Pickup
On Rodeo, Amigo, and Pickup (except 1993-95 models W/3.2L engine), connect the single wire diagnostic leads located behind the left hand kick panel together. On 1993-95 Rodeo models W/3.2 engine, the data link is located under the left hand side of the instrument panel. On all models, turn the ignition switch to the On position. At this point, the "Check Engine" light should flash. codes


25011203-uqsqk1sqel1nykdqv4diatnw-3-0.jpg 12pin version below.
jump pins,(for PCM errors) pins A > B
25011203-uqsqk1sqel1nykdqv4diatnw-3-1.gif
the codes are here.
http://www.troublecodes.net/isuzu/iszucel/





25011203-uqsqk1sqel1nykdqv4diatnw-3-3.jpg see no in the engine bay at all, like the 1 guess

Aug 26, 2014 | 1993 Isuzu Amigo

2 Answers

Where do i find all my oxygen sensors on my april 1993 isuzu rodeo?


The O2 sensors are located in the exhaust pipe just off the exhaust manifold. Here is a picture of your particular O2 sensor, some are slightly different looking it depends on the manufacturer. You will need to get under the truck to replace the sensor it takes a special 7/8" O2 sensor socket, about $5 from Autozone.


emissionwiz_236.jpg

Oct 20, 2011 | 1993 Isuzu Rodeo

1 Answer

Locationing temp sensor on 95 rodeo 3.2


There are SEVERAL temperature sensors on your vehicle (battery temperature sensor, intake air temperature sensor, evaporator temperature sensor, etc....you really should specify.

I will assume you mean the Engine Coolant Temperature (ECT) sensor.
If this is the one you are looking for, it is located at the rear of the intake manifold on the left side.

Jul 09, 2011 | 1995 Isuzu Rodeo

3 Answers

Temperter gauge not working


On the right side of engine on cylinder head there should be a single wire onto a small pole. Try removing that wire and see if your temp guage goes all the way up to hot. If it does, then the problem is with the sensor. If it doesn't then there is a problem with the wire and/or the guage itself. Replacing the sensor is quite easy. You will need a 7/8's deep socket to remove and re install, note you will lose a little coolant so make sure to top up with 50/50 mix of antifreeze and water.

Mar 15, 2011 | 1991 Isuzu Rodeo

1 Answer

I have a 1995 isuzu pickup it giving me error codes 15 and 34 and I've already been to 3 repair shops and can't get it fixed can you give me some help


I have the manual for my 93 rodeo and code 15 says ENGINE COOLANT TEMPERATURE SENSOR-SENSOR SIGNAL SHORTED, GROUNDED OR OUT OF RANGE. Check your coolant sensor by the water neck-it sends a signal to your dash gauge (coolant temp)
Code 34 my book has 2 symptoms- if its a 3.1 liter engine it says MAP SENSOR-SIGNAL VOLTAGE LOW-CHECK INCORRECT IDLE SPEED, VACUUM LEAKS, LOOSE AIR DUCT, MAP SENSOR CIRCUIT
If its NOT a 3.1 liter engine, then code 34 is EGR TEMPERATURE SENSOR CIRCUIT-SHORTED

Hope this helps.

Mar 19, 2010 | 1995 Isuzu Pickup

1 Answer

2001 Isuzu Rodeo 4 cyl 2.2L 2WD that is overheating


check the electric fan conector plug some times is rusti scratchet whit a sharp scruwdriver remove the rusti or dirt on it this happens many times and step two check the relay and thats it (this is the first step a mecanic to search)

Feb 07, 2010 | 2001 Isuzu Rodeo

1 Answer

1992 Isuzu Rodeo Heater only blowing cold air


Thermostat! or blockedf heater matrix, no idea where the thermostat is on that car never worked on one.

hope this helps

Jan 15, 2010 | 1993 Isuzu Rodeo

2 Answers

The engine misses on 3 and 4 and compression leaking into radiat


If you do in fact have compression (air) blowing in to the cooling systems this would show either a blown head gasket, warped head or cracked head. Please od not run the Rodeo until repaired as if coolant is getting in to the cylinder or oil (Your oil will look like chocolate shake) it can do severe damage. What motor please 3.0 V6?
THanks,
Tom

Nov 08, 2009 | 1993 Isuzu Rodeo

1 Answer

Just trying to find out where in is located looked every where


coolant temp sensor is hidden. you must remove exhaust shield and manifold to access it. it is behind the exhaust manifold.

Apr 23, 2009 | Isuzu Rodeo Cars & Trucks

Not finding what you are looking for?
1993 Isuzu Rodeo Logo

Related Topics:

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...