Question about 2004 Dodge Durango

2 Answers

I checked my fuses to see if any were blown after my dorango will not start or turn over . is there a reset switch

Posted by on

  • 2 more comments 
  • valdezdavid7 May 21, 2011

    my dodge ran just fine until i removed the fuses individuly checking for blown fuses when i was done i try to start it and the check engine light was blinking. all other component work is there a reset switch located somewhere

  • valdezdavid7 May 21, 2011

    just at fuse box under the hood . i wonder if it has something to do with the alarm if that has a kill switch to not let engine start?

  • valdezdavid7 May 21, 2011

    i am no wondering if by removing the fuse that the alarm uses that it has a kill switch and needs to reset some how.

  • valdezdavid7 May 21, 2011

    i found the problem .in my fuse box under the hood when i was checking my fuses
    i did not reinstall fuse in the correct location . at crank shaft fuse location .
    started up thank for your help.

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 318 Answers

No their is no reset switch. Does it make any noise at all when you turn the key to start?

Posted on May 21, 2011

  • Jeffery Lewis
    Jeffery Lewis May 21, 2011

    You are talking about the factory alarm or an aftermarket?

  • Jeffery Lewis
    Jeffery Lewis May 21, 2011

    you are welcome , have a good weekend come if you ever need help again.

×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

Have someone hold the key in the crank position while you (or someone) is underneath the vehicle and able to tap the starter with a small hammer. If it cranks, replace the starter. If it still does not crank, voltage needs to be tested at the starter to see if it is getting there. Let me know what you find. I may have directions to replace the starter if you wish to tackle it yourself.

Posted on May 21, 2011

  • Kori Policy
    Kori Policy May 21, 2011

    If you removed all fuses, the system thought it was being tampered with. This is going to need to be reflashed. There is no reset switch.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car alarm is causing my 99 dorango to not start how do i reset it


I have a 98 durango and when that happened to me the dealer had me put my key in the drivers door and lock and unlock the door 5 times with the key and it reset my alarm. It worked like a charm.

Oct 23, 2014 | 1999 Dodge Durango

1 Answer

1999 DORANGO TURNS OVER BUT WONT START


check spark and fuel 1st take off the air inlet from the airfilter you can shot some gas or brake cleaner or intake cleaner into the throttle area and try to start if starts fuel problem pump, fuses ,gas filter plugged if doesnt start take plug wire off the sparkplug and ground the wire to engine is there spark or not could also be crank sensor or if you have a oil sensor check if full of oil sometimes sensor cuts starting

May 27, 2014 | 1999 Dodge Durango

1 Answer

2006 325i bmw


The first thing to do would be to check all fuses. Sometimes a very random blown fuse can cause this. Also unhook the battery for one hour to reset all systems, and try a jump start if you have not just to be sure it isn't a battery issue. Also try locking/unlocking the key driver's door a few times using the key in the door. If the fuses are good and the battery reset does not help, nor a jump or key in the door, then there are a few other things that can cause this such as bad key - try another one, bad brake light switch, the switch is above the brake pedal, shifter not fully in park (auto transmission only) - try moving it around a bit, bad transmission position switch, bad clutch switch, dead starter/solenoid/relay or bad ignition switch/cylinder/start button.

Jul 03, 2013 | Cars & Trucks

2 Answers

You people ARE NOT ADDRESSING MY PROBLEM!!!! My car isn't getting ANY power to it since I hit a deer!! What do you suggest I do to start it??


There is a reset switch on your car that has to be reset, It is under the dash on the passenger side right behind the dash pannel. Or it may be behind the foot pannel on the side of the car. There is a button that you have to push in order to reset the switch. There will be a red light come on when it is reset. Good luck.

Nov 25, 2012 | 1992 Honda Accord

1 Answer

2001 cheve malibu. The Automatic lights, fuel guage, power windows quit working. The radio comes on when you turn off the switch but goes off when you turn it on.


It sounds like a short in your ignition switch. I assume you engine will not start? Check your fuses because if it is a short it should have blown a fuse or you would have smelled burning isolation from the wires. If you find a fuse blown it could give you a starting place to start checking. If the ignition fuse is blown it is in the ignition, wiring, starter or ignition key switch.

Aug 12, 2010 | 2001 Chevrolet Malibu

3 Answers

Changed fuse and brake light still doesnt work


Did you check for voltage at the light socket before replacing the fuse?
Was the fuse blown? If so, you need to find out why it blew. (fuses do not blow for no reason) If not, why did you replace it?

Did you check for voltage in and out of the brake switch? Brake switch failures are common on Dodge trucks. There should be voltage going in, but none coming out the other side until the brake pedal is depressed. If there is voltage going in, the fuse is not blown. If there is still no voltage on the other side when the brake pedal is depressed, then the brake switch is your problem-child.

The next step is to check for voltage in and out of the multifunction switch. (turn signal switch) The brake lamp voltage is switched on and off by the turn signal switch. Failure of the turn signal switch can cause a "no brake light" symptom. This is a common failure among most makes of vehicles. This failure can often be verified by stepping on the brake pedal and wiggling the turn signal switch. If the brake lights flicker on and off while doing this, the mutifunction switch needs to be replaced.

Oct 10, 2009 | 1994 Dodge Ram

1 Answer

1994 Buick Century Won't Start


no most likely have another problem u might have pushed another fuse out of socket check that then look for a power fuse check battery it may have drained whike the door was open or ing switch left on . u can clean battery post untill they shine and the battery cable ends toomake sure it is in park and for good measure turn key on foot on brake move into drive and back to park in case nutral safty switch was jammed

Jun 30, 2009 | 1994 Buick Century

2 Answers

Electrical troubleshooting reset feature locations


Look on the right side fender well at the main wiring and you will see a few fuse links,Just look for the one that is swollen or burnt.

Jun 01, 2009 | 1995 Ford Ranger Supercab

5 Answers

No Fuel 2001 Kia Sportage


dosee a KIA Sportage have fule pump reset and if so were is it ?

May 20, 2008 | 2001 Kia Sportage

Not finding what you are looking for?
2004 Dodge Durango Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...