Question about 2000 Chevrolet Blazer

2 Answers

Do 2000 chevy blazers with break pads have wheel cylinders?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,803 Answers

If you are asking if a vehicle equipped with four-wheel disc brakes has "wheel cylinders", then the answer is NO. Disc brakes do not use wheel cylinders. The calipers are what actuate the brakes. It works by the same principle however. The fluid travels down the brake lines from the master cylinder and presses on a piston. This is true for wheel cylinders as well as calipers.

On the other hand, the only trucks that GM manufactured with four-wheel disc brakes in the 2000 model year were the Sierra and the Silverado. Blazers were manufactured with front disc and rear drum brakes. So the answer to your question would be YES. It has wheel cylinders on the rear brakes.

Posted on May 21, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 4,977 Answers

Brakes pads go with calipers and disc brakes,brake shoes go with drum brakes which has wheel cylinders.

Posted on May 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abs


sounds like the anti lock pump is gloing out

Oct 27, 2012 | 1998 Chevrolet Blazer

4 Answers

Brake pedal to floor have replaced brake pads and master cylinder


Did the pedal go to the floor beforehand? Was the master cylinder leaking, and did you bleed it properly? If the master cylinder was not leaking, check your brake lines going to the rear wheels.

Jan 29, 2011 | 2000 Chevrolet Blazer

2 Answers

I need to replace the rear wheel cylinder and break shoes


So what is the question?
Nothing odd there,same a 55 chevy

Nov 06, 2010 | 1991 Chevrolet S-10 Blazer

1 Answer

1996 chevy blazer 4wd break petal goes all the way to the floor breaks r good new master cylinder blead all braks 10 times any sugesstins? help!!!


I know there is ABS in that vehicle, you might still have air in the ABS unit, you will need to get a manual that shows you the correct procedure to bleed the brakes. Master installed u need to start the bleed on the bench, then move to the ABS unit then to the individual calipers and/or wheel cylinders if equipped. I think there is a certain way to do it to avoid incorrect bleeding.

But i have also seen bad master cylinders brand new in the box.

Good Luck.

Aug 24, 2010 | 1996 Chevrolet Blazer

3 Answers

How replace turn signal switch 2000 chevy blazer?


Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.

Oct 07, 2009 | 2000 Chevrolet Blazer

1 Answer

I have a 2000 chevy blazer 4.3l engine\is backfiring


Start by checking each cylinder for spark with a good spark tester. A misifre is either spark or fuel, so you can cut the problem in half. The engine light is probably on due to the misfire.

Sep 20, 2009 | 2000 Chevrolet Blazer

1 Answer

2000 Chevy Blazer stuck in 4L


try putting in neutral then try shifting in to 2h

Aug 17, 2009 | 1999 Chevrolet Blazer

1 Answer

Airbag removal 2000 Chevy Blazer 4.3l


there should be 2 or 4 bolts/screws on the back of the steering wheel

Jul 18, 2009 | 2000 Chevrolet Blazer

1 Answer

1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks


have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.

Mar 11, 2009 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...