Question about 2007 Hyundai Santa Fe Limited

Open Question

Santa fe 2007 check engine light took to dealer for repair. was not even covered under extended warranty even though it was a senser repaid, the warranty does NOT mean fuel sensor. I was charged ^*( for repair and replacement, and went to pick it up and light was still on when cranked it up. sensor was bad they said on 2nd sensor and I refused to pay again for their assessment so they agree to pay for the part of &90. needless to say 8 days later the sensor went out again and I simply drive around with the light on. is there a simple fix? it appears when i remove the seat that if I had the proper tool I could change it my self with only a 2 wire connection accesible under the back seat.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1665 Answers

SOURCE: hyundai santa fe 2001

p0715 > A/T input speed sensor circuite05139a.jpg 1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. 2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. P1729>This DTC code is related to the EMC and is set If EMS harness has an open battery source addcfc2.jpg 1. Ignition OFF 2. M54 Electric Magnet Valve Clutch connector : Disconnect. 3. Measure resistance between 1 & 2. A. Specification : Approx. 1.8 ~ 2.2 Ωc7c6e73.gif The above value is only for reference. The data from vehicle may differ from it according as various vehicle condition. This inspection is for checking open or short of EMC coil.

Posted on Jun 16, 2008

  • 3614 Answers

SOURCE: hyundai santa fe 2001

FC P1529 means "Check TCM"

  • the vehicle is stuck in 3rd gear failsafe, this is what happens when there is a trans fault, but you made a big mistake.
  • you replaced the wrong sensor you put in a vehicle speed sensor wich calculates the rpm and speed of vehicle,,
  • your problem is an input and out put speed sensor wich is also located on top of the trans these sensors measure the speed of the input and out put shafts inside of the trans mission,,
  • you probably will not be able to get these sensors aftermarket, dealer item only i think

Posted on Jul 08, 2008

  • 840 Answers

SOURCE: Troubleshooting code P1167 for my 2002 Hyundai Santa Fe

Sensor Contamination Inspection 1. Visually/physically inspect following items: A. Remove and inspect the HO2S(B1S1) for any silicon contamination. This contamination will be indicated by a white powdery coating and this will result in a but false voltage signal. B. Check MAFS for contamination, deterioration, or damage. C. If contamination is evident on the HO2S or MAFS, replace contaminated sensor and go to next step.

Posted on Jan 25, 2009

  • 94 Answers

SOURCE: i have no spark on my 2001 4 cyl hyundai santa fe,i have

There is a very good chance the Crankshaft Position Sensor needs replaced. The CKP is what I replace the most for no spark on the 2.4 engine. It is behind the timing belt cover mounted above the crankshaft sprocket. Sometimes they just fail because the sensor was a bad part, other times teeth shear off of the timing belt and get in the wrong place and break the sensor.

Posted on Jun 30, 2009

  • 47 Answers

SOURCE: check engine light flashing, car shaking and smells like gas

it could be anything have the code checked odds are it is a bad sensor

Posted on Sep 26, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hyundai error report P0441 when check engine light comes on. Is this something covered under warranty at dealer, or should I have an independent mechanic look at it? Also, door latch that opens the gas...

yes this is a warranty item as it relates to the emission purge system ( pressure test for gas tank ). but before you go make sure your gas cap is tight (3 clicks) sometimes after getting fuel a loose gas cap will trip the purge solenoid valve to think there is a leak.

Feb 18, 2011 | 2007 Hyundai Santa Fe Limited

1 Answer

2007 hyundai santa fe mil light stays on. had in

if it is still under warranty,take it back to them,tell them to fix it right this time, and yes you can reset only if you have a handheld device to plug into you car,still doesn't solve the problem though,"TAKE IT BACK"

Dec 31, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

I was wondering if my timing hydraulic adjuster be covered under warranty,i have a 2004 santa fe and it has exactly 60,000 miles i bought it used with an extended warrantythat would equal to 100,000 miles.

extended warranties have limits call the 800 number or dealer and ask if ur problem is covered they have the list and limitations on your warranty

Nov 12, 2009 | 2004 Hyundai Santa Fe

1 Answer

Check engine and esc light comes on

Unless you have clocked up a load of miles, this fault can be dealt with under Warranty.

Aug 28, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Hi looking to find the alarm relay it exact location on a 2007 santa fe crtd i want to fit a sound box so when you lock and unock it i can have a sound from it also the seat belt warning sound anybody know...

2007 Santa Fe already equipped with 'ANSWER BACK' feature. Propably still under warranty. Take vehicle to Hyundai dealership.. .have it diagnosed.. find out FIRST if system is still under warranty.

Jun 23, 2009 | 2007 Hyundai Santa Fe Limited

2 Answers

My extended warranty only covers if i kept up with Maintenance

that is required if the belt breaks what happens usualy is the pistons will come up and hit your valvs ruening your heads and it wont be covered.

Jun 04, 2009 | 2006 Hyundai Santa Fe

1 Answer

2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Oct 28, 2008 | 2007 Hyundai Santa Fe Limited

1 Answer

2003 Hy Santa Fe with 105,000 mi. stalls occasionally but will refire right after.

Had this issue at 30,000 kms. Computer needed upgrade firmware/software (or whatever the appropriate term is) This was covered by the dealer (but was under warranty at the time). Enquire with your dealer

Jul 31, 2008 | 2001 Hyundai Santa Fe

Not finding what you are looking for?
2007 Hyundai Santa Fe Limited Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides