Question about Jeep CJ5

Open Question

Engine/starter wiring diagram for 1969 kaiser jeep cj5 w/225 vs

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6982 Answers

SOURCE: 1977 Jeep CJ5; Fuel issue. Can't get it pumped to

You can attach a siphon to the fuel line from the pump back to the tank and use it to detect any leaks in the line. You can also check the carb the same way, running it on fuel from siphon. If both check out OK, you can use an electric pump or replace the mechanical pump. Either should work providing that the "sock" inside the tank is not obstructed.

Posted on Jun 18, 2009

  • 86 Answers

SOURCE: a diagram of firing order for chevy 1969 307

the firing order is (18436572) and it moves clockwise.

Posted on Jul 31, 2009

ZJLimited
  • 17970 Answers

SOURCE: i need diagram showing me the firing order for a

CJ5 Jeep with a 304 engine

1 is the drivers side cylinder closest to the front of the vehicle.
1-----------------------2 3-----------------------4 5-----------------------6 7-----------------------8 DRIVER - PASSENGER

More details you can find in Autozone.com (free register).

Hope that helps.

Posted on Aug 27, 2009

  • 3600 Answers

SOURCE: can i get a diagram on how to disassemble my amc

Only place i know of is not free and it's http://www.alldatadiy.com and it will have all your tork information there, you will have to buy a crush sleeve oil seal and other parts to put it back together, and yo will need to know how to set up the gears as well. If you need more information plese post here.
Avid101

Posted on Aug 28, 2009

  • 2002 Answers

SOURCE: I just bought a 1979 cj5 jeep. Only thing wrong

The smartest way is to use a wiring diagram. Go to faxonautoliterature and they can fix you up with the original Jeep service manual which will have the diagrams you need, among other things. I have used them before and found their service to be excellent. Hope this helps.

Posted on Nov 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Jeep Compass Starter


Patrick J Farone wants answers to this question 2017
5 different engines, which one?>
USA car? why skip that,?
ever seen a starter ever,
ever do work on one ever? be key fact to know, right?
Patrick. most engines are the same, 99%
the only real question is it top or bottom access
but no engine stated so that cant be answered, the 2.4 is top


why piggy-back? generic>
1: pull neg. battery lug or boom eat acid and go blind.
2: jackup car, to stands, on jack stands,
3: see starter there, any shelds off now. gain access is NOW.
4: remove all wires to it now.
5: remove all base bolts, it falls and hits your head, duck please.
6: reverse above, should not have to be said but there.

watch 100s do it on Utube yet? no lack of examples there.
all cars same once seen with eyes have you?

now ill do 2.0/2.4L jeeps (from the SM, usa issue)
  1. Open hood.
  2. Remove air cleaner box and air tube.
  3. Disconnect and isolate the battery negative cable
  4. Remove starter motor mounting bolt.
  5. Disconnect the electrical connector at throttle body.
  6. Remove Throttle body bolts and remove throttle body.
  7. push starter under intake manifold.
  8. Tip starter nose toward cooling module.
  9. Pull starter up and out.
  10. Disconnect starter motor wiring.
  11. Remove starter motor from vehicle.

May 05, 2013 | 2007 Jeep Compass 2.4

1 Answer

Where is the crank shaft sensor 2000 jeep grand cherokee


It would be very helpful when you are asking for help with your vehicle if you would mention WHICH ENGINE your Jeep is equipped with. In many cases, since we are talking about a Jeep, it is also necessary to know if it is 2-wheel drive or 4-wheel drive. This makes a HUGE difference for many things including engine controls, transmission controls, and other components because even the wiring diagrams are different for these vehicles. (80% of all the problems that you will most likely have with your Jeep will be electrical or involve electrical/electronic components.)

With all that said,
On the V-8 4.7L (VIN code N) engine, the Crankshaft Position Sensor (CKP) is mounted into the engine block above the starter motor.
On the L-6 4.0L (VIN code S) engine, the Crankshaft Position Sensor (CKP) is mounted to the transmission bellhousing at the left/rear side of the engine block.

Oct 10, 2011 | 2000 Jeep Grand Cherokee

1 Answer

I have a 1989 jeep wrangler that two days ago we replaced the clutch and and did a trans up grade when we finished we tryed to start the jeep and we heard the the celinoid try to move the starter but was...


Not sure which engine you have, but here is diagram for 4-banger. I can get the others, but I think the starter curcuit will be the same. This may not be readable after download. Starter circuit is in upper left. I also attached a blowup that is better res.

277d39e.gif
2e8faf0.gif

Sep 10, 2010 | 1989 Jeep Wrangler

1 Answer

Alright, bought a 1989 Jeep Cherokee. Replaced


buy a hains manual from an auto parts store

May 10, 2010 | 1989 Jeep Cherokee

2 Answers

2006 Jeep Commander...cant find the starter???


iTS LOCATED AT THE BOTTOM OF THE ENGINE,AT THE REAR ON DRIVERSIDE,IN FRONT OF TRANY, HRERS A DIAGRAM TO SHOW YOU. HOPE THIS HELPS.3539ac6.gif

Mar 16, 2010 | 2006 Jeep Commander

1 Answer

Need a wiring diagram for a 1969 Ford F250.


there should be a slot for each wire on back of ignition play with them till you get it right cant hurt anything

Jan 14, 2010 | Ford F-250 Cars & Trucks

1 Answer

1969 chevy impala transmission wiring diagram


350 turbo? or 400 thd? makes a big difference i built tranny's for over 40 years

Jan 13, 2010 | Chevrolet Impala Cars & Trucks

1 Answer

Need wiring diagram for 1988 jeep comanche 4x4 6


check the solenoid on the starter it powers the ign for starting then switches to run when you let off key,either the solenoid is bad or a wire to the solenoid has come unhooked and sometime they have an in line fuse which can blow.

Sep 26, 2009 | 1988 Jeep Cherokee

1 Answer

Found a jeep with a identification tag on the rt firewall that reads Kaiser jeep corporation, toledo, ohio, serial # 3305 173918. would like to find the make and models of this old jeep. any help is...


Willys Overland merged with Kaiser and became Kaiser Jeep Corporation in 1963; AM Motors Corporation bought Kaiser in 1970. There is some interesting info at willysoverland.com

Sep 06, 2009 | 1983 Jeep CJ5

2 Answers

A diagram of firing order for chevy 1969 307


the firing order is (18436572) and it moves clockwise.

Jul 31, 2009 | Chevrolet Corvette Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...