Question about 1996 Chevrolet Blazer

1 Answer

My 96 chevy blazer will not start iput new pump spider injectors relaysand still will not start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 202 Answers

Coil? Even when these coils throw a spark sometimes it isnt strong enough.

Posted on May 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Chevy Blazer 4.3 4 wheel drive. It stalled and would not start again. The garage said the fuel pump and fuel regulator first , hen they replaced that they now say its the spider assembly on...


No.
The spider is one injector that supplies six small lines going to the cylinders instead of having one injector for each cylinder.
I would ask for a partial refund for parts and/or labor on the fuel pump job if that did not fix the problem. They should apply some or most of that cost to the cost of replacing the injector assembly if they diagnosed the problem as being the pump first.

Feb 20, 2014 | Cars & Trucks

1 Answer

Not getting fire to my injector


No fuse is protecting the control. However you must test the following see the diagram.test the cable+the spark plug and coil can be faulty completely.+God bless you3_22_2013_6_17_03_pm.jpg3_22_2013_6_17_24_pm.jpg3_22_2013_6_18_01_pm.jpg3_22_2013_6_18_29_pm.jpg3_22_2013_6_18_56_pm.jpg3_22_2013_6_19_19_pm.jpg

Mar 22, 2013 | 1993 Chevrolet S-10 Blazer

1 Answer

My 2002 Chevy Blazer won't start?


If you replaced the injector after the plugsthey may be fuel fouled.Pull the plugs and clean them.(you can sandblast them,or use a method I used to use-shoot a little starting fluid on them and use a lighter to burn off the contamination of too much fuel).I can't believe GM kept using this stupid design so long-I remember nearly new Vortec V6s with this same problem in the '90s.

Oct 07, 2012 | 2002 Chevrolet Blazer

1 Answer

Blazer 1999 won't start got spark new fuel pump


Pull off one injector connector and use a test light or voltmeter to see if one wire has power with key on.
Power to the injectors is fed through the ignition switch, so with key on, you should have power there. The injector ground is inside the ECM. If you have power, you'll have to diagnose the circuit for why computer doesn't ground the circuit when it should.

Nov 06, 2011 | 1999 Chevrolet Blazer

1 Answer

My 96 s10 blazer has fuel pressure to the injectors whitch are spider injectors but will not start


I had a 2000 chevy Blazer that had the same problem. I ended up replacing the spider injectors from the local parts house and solved my problem. The computer was sending to open them but they didnt in which it wouldnt run. Hope that helps.

May 19, 2011 | 1996 Chevrolet Blazer

2 Answers

I have a 1998 Chevy Blazer 4.3 Vortech that will not start.


You may want to check your fuel regulator and check your injectors. Had the same issue with a 96 and replaced the whole CSFI spider assembly with a MFI spider assembly and problem was solved.

Dec 29, 2009 | 1998 Chevrolet Blazer

1 Answer

Have code for cylinder #1 misfire on 96 chevy blazer engine runs rough at idle what do i need to do


these were bad for the spider injectors to fail. they are hard to diagnose with out the scan tool. the poppets in the end of the injectors get clogged and will need to be replaced. pull the plug and see if its oil fouled. they also have a problem with the #1 cyl getting out of round and oil fouling the plug. compare it to another plug in the engine. if its oil fouled the engine is no good.

Nov 06, 2009 | 1996 Chevrolet Blazer

3 Answers

Know if my 95 chevy blazer has a spider CPI?


A spider injector is located underneath the intake plenum and this is multi-port. Otherwise you have a throttle body injector system. Vortec engines have spider injectors and they are super expensive to replace ($400.00- 850.00) each ! There is only one spider injector for each engine it has 6 legs/fuel tubes that go to each cylinder.

Oct 10, 2009 | 1995 Chevrolet Blazer

1 Answer

93 Chevy Blazer S-10 4.3L F.I.


if this is the vortec engine you may want to check to confirm that the injector pot is working. The injector pot is located under the air intake manifold (top half only) & PLEASE BE SURE TO DISCONECT BATTERY FIRST. if you unbolt the top half of the intake manifold you will find the main injector pot otherwise known as the SPIDER. This part does have a history of failing and can be very costly to replace if you purchase it new. most junk yards should be able to find one for you.

Feb 15, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...