Question about 2002 Chevrolet Impala

1 Answer

Where is control module on 2002 Impala - 2002 Chevrolet Impala

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

Look under the dash by the drivers left foot kick panel.

Posted on May 20, 2011

Testimonial: "thanks for the answer"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 Chevy impala 3.8 doesn't start sometimes. When it doesn't start I have fuel no injector pulse no spark but I do have cam signal. Replaced ignition control module but no change!


Coil is probly bad. Unplug computer and clean that area. Olders cars have issues w dirty pins. The injector drivers in computr may be worn. Adata stream run w a factory scan tool is a must

May 26, 2015 | 2002 Chevrolet Impala

1 Answer

What is required to reprogram Body Control Module 2002 impala


this requires a scan tool that has the capability to reprogram the BCM to the specific car.

Sep 10, 2014 | 2002 Chevrolet Impala

1 Answer

My 2002 impala radio heater blower and lights wont shut off after car car is off stays on till i disconnect the battery.


There may be a keep-alive relay or module that lets you play the radio after you turn the key off until you open the door.
This relay or module may have failed. Thats actually three different circuits but two are controlled by the key switch.
You may have to get a shop manual to troubleshoot the circuits.

Sep 22, 2012 | 2002 Chevrolet Impala

1 Answer

2002 chevy impala ignition control module problem


The engine and the automatic transmission in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine.

Sep 12, 2012 | 2002 Chevrolet Impala

1 Answer

My 2002 chevy impala's driver information system and air condition will not come on, what could be causing this?


All of this stuff is electronically controlled by a module, have it scanned for fault codes and proper operation.

Jun 14, 2012 | 2002 Chevrolet Impala

1 Answer

Why does my 2002 chevy impala not start when the airbag light is on?


The airbag light has absolutely noting to do with the engine starting unless it is because the airbag module is losing power at the same time that some engine component is losing power due to a defective ignition, battery, or ground circuit.

The best thing to do is to scan your computer network for possible fault codes that may lead you to the cause. Please note that I said "computer network", NOT engine control module. Most generic OBD code readers (like those used at many parts stores as a sales tool to sell you a bunch of stuff you don't need) cannot access anything but the continuous memory in the engine control module....you need to scan ALL modules.

Jan 26, 2012 | 2002 Chevrolet Impala

1 Answer

Whee is the passlock located on a 2002 chevy impala


it is integral to the body control module

Nov 10, 2009 | 2002 Chevrolet Impala

1 Answer

I have a 02 chevy impala that sometimes wont turn on.


Anti theft problem Ignition lock cylinder or Body control module

Jun 27, 2009 | 2002 Chevrolet Impala

1 Answer

Every now and then the car will not start security interups starting 2002 impala


Have a shop that specializes in the eletric systems on your car test the Body Control Module (BCM). This is a weak spot on many GM products. A new BCM for an Impala should cost about $230, plan on another $200 for the diagnosis, replacment, and programming. The dealers typically want between $700 and $1,100 for this.

May 17, 2009 | 2002 Chevrolet Impala

1 Answer

Need to turn off airbag


disconnect the airbag control/diagnostic module, but the light will stay on in the dash.

Mar 30, 2009 | 2002 Chevrolet Impala

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...