Question about 2002 Mazda MPV

1 Answer

My MAzda 2003 MPV ES.The evap and EGR still incomplete, need reset on the monitor- drive test; everything else passed the smog. no codes show on scanner. FEw months ago, I chage the battery, but I was told the much time lapsed, it should have reset the monitor. If I just have one of these reset ,my smog will go through.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Mazda Expert
  • 106 Answers

Here is the procedure for allowing system to run each of the separate mode tests.
EGR : Start engine and warm up completely. Make sure all electrical loads are off (A/C headlights, blower fan, and rear window defroster) Accelerate to between 49-57 mph and hold a very steady speed for 1 minute. Decelerate to a stop and turn off engine.
EVAP : Ensure Baro pressure is 21.3 inHg or higher, Intake air temp is 41-95 'F, Fuel tank level is between 25-75%, Battery voltage is 10.9-14.6 volts. Start engine and idle for more than 10 seconds then turn key to off. Leave vehicle to sit for 5 hours or more. Start engine and race to 3500 rpm to warm up completely the idle for more than 15 minutes. Accelerate and then drive vehicle at very steady speed between 40-50 mph for more than 5 minutes. Stop vehicle and turn key to off. Leave vehicle undisturbed for 20 minutes or more.
When I say steady speed in the above, try to keep dead on to a set speed to help ensure the test is run. Especially for the EGR as this is when the test will be performed and if speed/rpm is not very steady then test will not be performed. The Evap test will be ran during that final 20 minute or more sitting period (or should be anyway).

Posted on May 20, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My '11 Mazda 3 has batt disconnected. Need emission test to renew reg Do I need to do anything to reset computers for it to pass the test


U need various driving condition for couple of days or so includes freeway driving for about 20 minutes to set your computer monitors ready to pass the OBD testing part I would first ask the smog tech to pre-check d computer if ready before testing.
Good Luck

Dec 12, 2016 | 2011 Mazda 3

1 Answer

What is the drive cycle computer rest for 2010 corolla


drive cycle, why not just forget that. I do. (mostly)
why>?
what do I do, i reset the PCM with my $10 scan tool
when dont, all monitors are now reset, ALL !

drive cycles to finish off all monitors? (a goal for say smog testing)

that is easy most clear fast. running fast.
but not EVAP, can take up to 30min but
if fuel tank is fuel, it never completes EVAP until 1/4 lower, 3/4 full and less.
EGR tests? can be easy if you drive fast, and then coast to a stop
both tests cleared. (sans complete)
monitors are (no appliclable, not ready or complete)
to do smog, all must be complete and no DTCs. (rare exceptions)

the drive cycle means number of times it takes to set a code for one test monitor or clear one.
some newer cars take 2 drives to set them.
and is important, the FSM covers this.
why not post symptoms or reasons for asking.

just curious?, then read the ASE book on OBD2 technology.

alldata.com RTM.

Oct 10, 2014 | 2010 Toyota Corolla

1 Answer

Evap and cat converter monitor not showing ready when trying to smog 2001 daewoo nubira


you hav'nt mentioned the car, but i'd get the OBD codes read as will show which sensor/switch is at fault

Jul 04, 2014 | Daewoo Nubira Cars & Trucks

1 Answer

Mazda MPV 2003, Engine light on, code P0421 - warm up catalyst efficiency below threshold bank 1


could anyone please help me with this problem that i have with my 2001 mazda protege es 2.0. i have a bad catalyst converter and im waiting for the converter to come in, but before the guys that are fixing on my car relize that i need a converter they put a egr valve and a o2 senor and when the car idle some time it will just die one me. could someone tell me what is going on.

Nov 30, 2010 | 2003 Mazda MPV

1 Answer

1999 Subruban 1500 LT Failed Emissions Test: Catalyst Not Ready EVAP Not Ready O2 Sens HTR Not Ready EGR Not Ready Fault Codes: No codes Present -------> Check Engine light is not on.


You may have a defective coolant or air temp sensor. These need to be accurate in order for some of the monitors to run. Your going to need a diagnostic scanner to see the data so you can determine what is wrong.

If you had replaced or unhooked the battery just pryor to geting the smog then thats the problem. Just drive the truck for a couple days and you should be fine.

You will still pass the test if you still have 2 monitors not set. California allows that. 3 fail

Feb 18, 2010 | 1999 Chevrolet Suburban

1 Answer

Evap Sys Monitor


if evap is the only monitor that hasn't set yet, the car should still pass, a car is allowed to have 1 monitor that isn't set and still pass as long as the check engine light isn't on. take it in for the emissions, it should pass.

Jul 04, 2009 | 1997 Chevrolet Malibu

1 Answer

How do you fix a fuel evap in a 1994 Mazda B2300 truck. It is not passing smog.


sorry, to my knowledge there is no fix...there IS however a fuel additive available that will allow you to pass the Smog test...Google "pass Smog emissions test..."
Good Luck

Jun 15, 2009 | Mazda B2300 Cars & Trucks

Not finding what you are looking for?
2002 Mazda MPV Logo

1,242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...