Question about Chevrolet Malibu

1 Answer

Where is the oil sending unit on a 99 Malibu 3.1 L

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,170 Answers

Hello,
The fuel sending is in the fuel tank mounted on the fuel pump module.

Thanks

Posted on May 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil sending unit located on a 2002 chevrolet malibu


V6 ENGINE OIL PRESSURE SENDING UNIT LOCATION NEXT TO OIL FILTER. THE 4 CYLINDER ENGINE OIL PRESSURE SENDING UNIT LOCATION IS FRONT CAMSHAFT HOUSING ON THE LEFT DRIVER SIDE OF THE ENGINE COMPARTMENT.

Mar 20, 2011 | 2002 Chevrolet Malibu

1 Answer

I need to locate the fuse for my gas gauge in my 99 malibu


There is no fuse specific to the fuel gauge. The Instrument panel has two fuses that supply power to everything it has on it. The fuel gauge signal is received from the body control module which sends out a signal voltage to the fuel level sending unit. Depending on where the float in the tank in determines how much resistance the sending unit has. the body control module interprets the voltage value into a fuel level and sends a signal to the gauge.

If the gauge is not working the most common cause is the sending unit in the tank.

Nov 11, 2010 | 1999 Chevrolet Malibu

1 Answer

Oil Pressure low


that is low, i recommend you pull the oil pan and check the pump pickup tube screen, it may be the oil pump but i doubt it, my guess is internal engine wear

Jul 29, 2010 | 2003 Chevrolet Malibu

1 Answer

1998 Malibu 2.4 Litre 4cyl. oil leak under exhaust manifold.Are there any sending units attached to the engine block?


Yes you have an oil pressure sending unit (switch) located under the manifold. They are known for going bad and leaking. Eventually it will prevent truck from running. When it stops sensing oil pressure due to the leak the vehicles fuel system will shut off. Its a saftey featur to keep you from blowing the motoe if a pump goes bad or you run outta oil

Mar 08, 2010 | 1998 Chevrolet Malibu

1 Answer

Alight comes on that looks like a pail with a spout on a 2003 malibu with a 3100 engine it gones off at about 2700 rpms


it sounds like your oil pressure light. ( light illuminates red) I would check the oil level in the motor, if o.k. check oil pressure with mechanical gauge at sending unit located on engine. If oil pressure above 18 p.s.i. at idle, suspect faulty sending switch. If pressure low, possible oil pump/regulator, cracked pick-up tube, bad engine bearings.

Dec 26, 2009 | 2003 Chevrolet Malibu

1 Answer

My malibu's oil pressure light came on while driving and then when i hit the gas pedal it acted like i ran out of gas but had a full tank and then shut off


Oil pressure sending unit shuts off fuel pump if there is a problem with the unit (Oil pressure sending unit maybe malfunctioning)

Nov 24, 2009 | 1999 Chevrolet Malibu

1 Answer

Car wont stay started


Get the fuel pressure tested. Might need to change the fuel filter or (Worst case) the sending unit

Jun 02, 2009 | 1999 Chevrolet Malibu

1 Answer

What is a oil sending unit on 99 chevy venture van?


easy to change u just need a special tool for removed on front of motor at right of oil filter its look like a coolant sensor or a little bottle with a connetor removed the connector and take the tool to remove

Oct 11, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...