Question about Renault Fuego

1 Answer

TIMING IS OFF. WHEN CAR COMES TO COMPLETE STOP, IT SWITCHES OFF, REV IS TO LOW.PLEASE ADVISE ON HOW TO SET THIS.THANKS

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Try to check & adjust the accelerator pedal. If it doesnt work try checking the fuel for water contaminants.

Posted on May 20, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car keeps running when I turn it off


If it "runs on" (like it's trying to stop but can't) then your timing is not set correctly, most likely too advanced. Depends entirely on the make, model and year of your car. Newer cars depend on sensors to set timing many times per second. If your car just keeps running and WON'T stop, you need to see a licensed, dependable auto mechanic, preferably at the dealership. Your car may be covered under a "RECALL" for ignition switches.

Sep 03, 2014 | Cars & Trucks

1 Answer

Fuel pressure spark car wont start


code p0341 refers to cam shaft position sensor(CMP)sensor A bank1---range/performance problem===causes--insecure sensor/ rotor---air gap---wiring---CMP sensor.. I would pay attention to the sensor and the possible causes as listed because the timing of the engine is related to the position of the cam shaft. Timing is computer controlled and will not be "off" unless the CPU cannot get a definite position of the piston to set the timing

Mar 05, 2014 | Volkswagen Golf Cars & Trucks

1 Answer

1998 mitsubishi galant revs high then low when idling. runs fine but it sounds horrible.


that is your idle air control valve. it is located on the throttle body next to the throttle position sensor

Dec 15, 2012 | 1998 Mitsubishi Galant

1 Answer

Do the valves need to be set on timing?


please be more specific and a bit more technical because i think you are a bit misguided here as the combustion chamber valves are hydraulic which means they are self adjusting .

Nov 18, 2012 | 2001 Mitsubishi Galant

1 Answer

Car was runing fine then massive loss of power after comming to complete stop and tryin to accelerate as if was not running on all cylindars or out of gas it bogs but r.p.m.s rev high


You are going to have to inspect for a timing belt, the 1.6, 1.8 has a hydraulic tensioner if it looses its tension you wont run on all cylinder and you will bog down and yet be able to rev high. you will need to change t-belt and the t belt tensioner

Jun 01, 2011 | 2001 Hyundai Accent

1 Answer

Engine starts but does not rev up


Double check the timing marks on the crankshaft and cam pullies. I bet your off by a tooth after replacing the timing belt.

Sep 10, 2009 | 2004 Ford Focus

1 Answer

Engine goes off at stops


idle speed set too low - or check the torque converter solenoid

Aug 04, 2009 | 1999 Isuzu Rodeo

2 Answers

Valvetronic internal fault and servomotor power limited


Hi I have a 2003 318i se saloon it started to loose power a few weeks ago now when you rev it up it makes a noise through the inlet manifold like its a dump valve it still drives but with very reduced power i had a new exhaust fitted yesterday with a new cat as i was told the cat had collapsed been told it could be the timing chain other than that i have not got any idea can any one help please.

Mar 11, 2009 | 2000 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

xxxxxx xxx

Level 3 Expert

4860 Answers

yadayada
yadayada

Level 3 Expert

76051 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...