Question about 1995 Ford F150 Styleside Regular Cab

1 Answer

1995 ford f150 - truck ran fine.turned on turn signal and started around turn and truck shut off and will not start.it has no fuel pressure in fuel rail and no diagrams for fuel pump relay's location.all the relays in under hood fuse pannel are the same number and has no markings as to where they go.have not been able to find a diagram for this truck.i bought it used and it had no owners book.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 7,766 Answers

You can get a 1996 manual at the link below. That may be close enough. It shows 5 relays in the box under the hood. Relay 2 is for the fuel pump. Your wiring diagrams are at the second link below, and the particular diagram for the relay is at the third link.

http://www.fleet.ford.com/partsandservice/owner-manuals
http://www.bbbind.com/free_tsb.html

http://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=2020

Posted on Aug 07, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: 1992 ford ranger

If this speratic problem seams to happen most when it's raining or damp, it is a shorting master contol that is to blame. The master control mother board is located on the firewall. Over time, the moisture seal on the cover fails and the motherboard gets damp and meny false signals are sent. This can even happen if the truck is off and key is not in the ignition (this mother board will alwas have power going to it as long as the battery is connected). A cheap way to check this is to remove the cover, put a plastic grocery bag over the mother board and use an small elastic band to close the open end, allow the wires connected to the mother board to go out the open end. If this solves the problem, replace the seals on the master control cover. Care should be taken as if there is ANY corrossion on the mother board, it will need to be replaced.

Posted on Oct 28, 2008

SOURCE: i need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram

Hi

go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.

Good luck and I hope this will awnser your question.

Posted on Nov 08, 2008

  • 140 Answers

SOURCE: where is the fuel pump and which relay goes to it? f150, 5.0 efi-

it is in the fuel tank.. drop the tank, remove little snap ring on top of tank, and pull the old fuel pump assembly out, then just replace the old one with the new one.. good luck keith...

Posted on Mar 21, 2009

motor1258
  • 6674 Answers

SOURCE: Fuel pumps will not run!

Hey lets try this ! Locate your starter solenoid & look for a yellow wire marked with a "W" . That may be the fusible link for fuel pump. Let me know what you find.

Posted on Apr 14, 2009

seans46
  • 161 Answers

SOURCE: Diagram or proper schematic of fuel pump relay

The Owners Manual under Relays will tell you the location of it. If for some reason it doesnt emial me and I will find it for you. seans46@yahoo.com

Posted on May 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 93 Ford F150 4.9 liter. And when I go to start it the fuel pump stays running for close to four minutes and then it will not start until the fuel pump shuts off?


OK, when you turn the key to on, it will start the pump for about 2 seconds-this is just to put pressure in the lines and in the fuel rail for easy starting. If key is not turned to start, pump will shut off after 2 seconds. But when cranking in start, and when engine is running, the pump is on full time.
If your pump runs longer than 2 seconds with key only in on position, you have a fuel circuit problem. It very well could be a bad fuel pump relay staying on. Or it could be a computer problem signaling the relay to stay on longer. Try a new fuel pump relay first and see if that was the problem.

Oct 07, 2016 | 1993 Ford F150 SuperCab

2 Answers

My 2001 Tahoe ran fine going to work. When I got off work, I started it up and it ran for 20 seconds then shut off. started again and started to go home. It jerked twice then ran 100 yards then shut off....


Check the crank position sensor. Also it could be as simple as a bad coil or coil wire. It definitely sounds electrical if you hear fuel pump priming. Also check distributor cap and rotor. Hope this helps

Jan 24, 2015 | 2001 Chevrolet Tahoe

1 Answer

What are typical reasons a 2003 Ford F150 will not start? The enginge turns over fine but will not start


Will turn over bit no start? Fist thing to check is fuel system, get a pressure reading. Key on fuel pressure needs to be minimum 40 PSI

May 04, 2014 | Ford F-150 Cars & Trucks

1 Answer

Fuel pumps not working. Have changed eec relay, fuel pump relay, checked fuse and inercia switch not triped. Any suggestions?


When you turn the key to "ON', or "START" the fuel pump should run just enough to pressurize the system, and shut off. When engine is actually started, the pump will run continuously. Sounds like the pump relay is not getting the signal to run the pump from the key being turned to "on" or "start". Also, some vehicles can sense fuel pressure so there may be an issue with that sensor as well. In other words it thinks there is proper pressure or maybe too much pressure and wont let the pump run. I am curious to know what you find.

Aug 19, 2011 | 1991 Ford F150

1 Answer

I have a 2001 ford f150 5.4 v8. I shut it off and when I tried to restart the truck it would crank over fine but not start. starter turns fine and there's plenty of fuel. Truck ran fine prior to failing...


Check fuel injection. Could be a fuse or module. Also check to see if fully in park or in neutral.
Most likely electrical side of ignition. Since plugs, cap and wires are out of the way, it is most likely in the fuse panel.

Jan 04, 2011 | 2001 Ford F150 Styleside SuperCrew

1 Answer

My 1995 ford f150 v8 302 will not start


Ford truck was running fine then it just shut's OFF, afterwards did start once stayed on for a couple of minutes then shut off again. A friend thinks it's the computer after checking the car. Note I did pressure wash the engine 2 day's before and didn't use it till now.

Nov 08, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

95 f150 will turn over but not start. If it sits


Sounds like fuel pump or fuel pump relay but most likely pump. If the pump get too hot after running, the pump will not build up enough pressure to start but after sitting, it will cool off enough to build up the proper fuel pressure.

Another thing to check is the ignition module for the distributer. They are known to heat soak also however you typiocally get a cut out or miss feel when those have issues.

Sep 13, 2009 | 1995 Ford F150 Styleside Regular Cab

2 Answers

Hi got a ford f150 1986 f/i will not start


check fuel pressure @ service port on fuel rail. also listen for fuel pump to come on when you first turn on key. pump is in fuel tank. also note i have seen a lot of f150 302 injectors clogg up.but that usually effect idle and performance. if there is good fuel pressure then check fuel injector signal with a tester called a noid light. it is inexpensive and can be found @ most auto part stores. you really should'nt check injector signals with a standard 12 volt testlight. it has been known to burnout the drivers on the ecu. test all that first.

Aug 04, 2009 | 1986 Ford F150 SuperCab

1 Answer

Fuel pump relay & fuel pump


when you turn the key on the pump should run to purge the system . so now you have fuel pressure for starting. this stage lasts about 10 seconds then the fuel pump doesnt turn on again till the computer see's oil pressure then turns the pump on. if the inertia switch has been activated it wont send the first amount of fuel.

Jul 26, 2008 | 1996 Ford F150 Regular Cab

Not finding what you are looking for?
1995 Ford F150 Styleside Regular Cab Logo

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...