Question about 2006 Volkswagen Jetta

1 Answer

Need to replace drivers airbag on 2006 volkswagen jetta.i need directions in taking it off and replacing

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 188 Answers

Hi,its not a good idea to do it ur self it can be dangeres but I can assist u.u need to disconnect the battery first.then if u turn the steering a bit of senter at the back there is holes on each side of steering get the steering on its neerest to u and get a small flat screwdriver and wedge the clip on each side of steering and airbag will come out,this is very difucalt so try to get a mirror and a light to see into holes.hope this will help.

Posted on May 21, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for airbag in 2006 jetta


fuse box lower dash drivers side lid/cover should give fuse listing

Jul 02, 2014 | 2006 Volkswagen Jetta

1 Answer

The turn signals for my 2002 Volkswagen Jetta TDI work great, except the clicking noise keeps going well after the turn has been made and the clicker turned off, etc. All the bulbs are in working...


More than likely you've got a short in the turn signal switch. I have replaced a few of them.
It's easy to replace, but you need some specific tools and getting the airbag out takes some practice.

Jan 09, 2011 | 2001 Volkswagen Jetta TDI

1 Answer

I have a 2006 jetta 2.5 automatic. the airbag warning light comes on although there seems to be no problem. A lamp light stays on even though i have no headlight or turn/backup/break light/trunsignal...


My jetta 2.5 2006 had a defective wire harness in the driver's door with cracked insulation causing intermittent short-circuits bringing battery discharge and no start-up in the morning.
I suspect all the cars that had their wiring made with the same roll of wire will experiment similar problems.
Jean-Pierre jprbb@hotmail.com

Dec 29, 2010 | 2006 Volkswagen Jetta

2 Answers

How do I reset the airbag light on my 2006 VW Jetta


how do i reset srs airbag indicator light

Dec 01, 2010 | 2006 Volkswagen Jetta

2 Answers

Airbag light staying on


You need to connect to vag com or some else computer program to see the error code and when remove prroblem you need to delet the error from car computer memory to get rid of the light.
The most common problems are: blown fuse, bad connection under the seat or something like that! But you can't do nothing without the comp.

Nov 30, 2010 | 2006 Volkswagen Jetta

1 Answer

Passenger side airbag warning light is on?


Hi there It can be that the airbag was switched of for a baby seat. Other wise you will have to take it to a dealer so that they can diagnose the fault. be careful to try and do your own repair's, airbags can be very dangeris

Nov 23, 2010 | 2006 Volkswagen Jetta

1 Answer

I have 2006 jetta that has an airbag code of 02511.


That hase something with the seat, airbag or seat occupied recognition, and you need to check the wires and connectors onder the seat, clean them and connect them surely. But still you need to connect to vag com to delete error crom car omp.

Nov 07, 2010 | 2006 Volkswagen Jetta

1 Answer

Car cranks but won't start. checked fuses, attempted scan but unable t o connect. Service engine light blank with key on, should be lit


sounds like ecu problem just did on other day, can happen if ignition has been replace or driver airbag was removed, ecu gets scrambled after about 3000k. hope this helps. ( rate me thanks )

Aug 30, 2010 | 2006 Volkswagen Jetta

1 Answer

Airbag lamp stays on a 98 VW Jetta,


you need diagnostic equipment.
marko

Sep 21, 2009 | 1998 Volkswagen Jetta

Not finding what you are looking for?
2006 Volkswagen Jetta Logo

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...