Question about Jeep Liberty
The cable may have worn out the plastic wheel and the hole unit has to be replaced.......Hope this helps.
Posted on May 20, 2011
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Apr 14, 2013 | 1987 Chevrolet Corvette
Nov 26, 2012 | 2005 Chevrolet Chevrolet Malibu LS
Oct 09, 2012 | 2000 Volvo S40
Jan 13, 2018 | Toyota Matrix Cars & Trucks
Aug 10, 2012 | 1999 Volkswagen Beetle
May 06, 2012 | 1999 Ford Explorer
Mar 12, 2017 | 1998 Chevrolet Camaro
Nov 04, 2011 | 1990 Mercury Cougar
Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows are controlled thru and get power from the master control switch on the drivers door.
Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit. Check that all switches return to neutral when released.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes that's all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exists. Make sure to check for voltage coming to that windows switch. Actually, GM use's a circuit breaker type relay for each window and one fuse for all the circuit breakers.
Open the door, turn the key to the ON position without starting the engine and everything that makes noise is off. Lean down placing your ears close to the bottom center of the door or at the speaker grill. Press the window switch UP and DOWN. Listen for the window motor. If heard the drive is damaged. If not heard, turn key off and locate and replace the relay with one of the other window relays. Check window again. If it works now, get a new relay. More often than not, removing the motor and turning it by hand will get it working good as new. I have had to do that with Brand New motors! So try it.
If all has failed, with the door panel still off, check for voltage at the motor connector when pushing the window switch. No voltage means its the switch, especially if its a auto down or up switch.
You may also find that the connector has simply come loose from the master window control. Good luck!!
Aug 19, 2011 | 1996 Oldsmobile Aurora
25 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: