Question about 2002 Chevrolet Malibu

1 Answer

Heater fan only works on high speed # 5 - 2002 Chevrolet Malibu

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

Replce heater resistor located up stream from blower motor

Posted on May 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need the location of the fan resistor,


More likely it's your fan speed switch. If the resistor pack goes bad, usually fan only works on high speed, but is still turned on and off by the fan switch. If yours stays on all time with key on, and won't turn off by the fan switch, probably a bad fan switch.
The resistor will be on the heater case, mounted with two small screws, a small rectangle with a wire connector with 4 or 5 wires to it, and not far from the blower motor.

Dec 20, 2013 | 1997 Chrysler LHS

1 Answer

Heater / air conditioner fan control doesn't engage fan. Previously, it only worked in high speed.


I would replace the blower motor resistor first then see if that corrects this. The resistor is located next to the blower motor under the dash.

Jul 16, 2012 | Cars & Trucks

1 Answer

AC and Heater fan will only work on high speed, all fuses good. any ideas thanks, Dave


When the blower fan will only work on high speed setting this means the fans speed control resistor is burned out, when it fails the fan defaults to high speed only. The fan resistor is located next to the fan and held into the cooling air duct by 2 screws near the blower motor. The part is fairly cheap and easy to replace.

May 11, 2011 | 2000 Mercury Villager

1 Answer

The low/med/high fan switch on my 1985 Toyota pickup is no longer working, How do I replace the heater fan blower switch?


Hi,
Don't go there just yet ! Most heater motor speed problems relate to the heater resistor ! It's located in the ducting close to the motor assy and usually has 4/5 wires on to it and a 2 screw fixing. This componant must be cooled (hence air duct location) and is solely responsible for motor speeds ! You can check motor fan by test lamp/meter ! Good Luck

Dec 13, 2010 | 1985 Toyota Pickup

1 Answer

Heater controls


It may be your blower motor RESISTOR, in gm cars it may look like a card that is connected near the blower motor,under the dash, on most cars this is what gives you variable speeds, except on the HIGH speed is usually wired directly to the battery through a relay.

Mar 29, 2010 | 2001 GMC Yukon

3 Answers

Heater fan only works on the high position?


There is a plug up under the glove box that loosens and you need to snug it up.

Dec 09, 2009 | 2004 GMC Canyon

1 Answer

My chevy ac blows only on fan speed 5 what could it be


It is a 99% chance you need a new fan speed resistor board.
It is beside the fan motor.... it sits in the heater/AC duct work to use the air flow to cool itself.
It costs about $35 and takes 15 mins to change.
Did you loose one speed then another and now only high works?
That's the usual way they fail.

Sep 18, 2009 | 1995 GMC Suburban

1 Answer

Heater blower motor only works on high on 2002 pontiac gran prix se-instructions on diy replacement i have the part. Heater Fan works occasionally on speed 5 only. When it doesn't work at all the lights...


for the fan blower motor it could be the resistor or the fan control speed control switch is bad.for no lights replace the DRL RELAY for the lights. for the heated seats check the fuses.

Jun 01, 2009 | 2002 Pontiac Grand Prix

3 Answers

Heat/AC Blower fan speed only works on High


Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.

Jan 14, 2009 | 2005 Jeep Grand Cherokee

2 Answers

A/C and Heater Only works on the highest speed


The blower motor resister is bad...It is very common in chevy trucks. The resister is located behind the glove box and is held in place by two screws, it will also have a wire harness attached to it. If you want to see a picture of it go to www.partsamerica.com and search for the blower motor resister.

Nov 25, 2008 | 2003 Chevrolet Tahoe

Not finding what you are looking for?
2002 Chevrolet Malibu Logo

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...