Question about Chevrolet 1500

1 Answer

The truck starts and idles fine but when put in drive the truck stalls out and wont start without being primed.the fuel pump has been replaced and also the air idle speed controller but i was wondering if it needs to be adjusted and if so how to do it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

What is the year, make and model? Does it stall slowly or abrupt? the Idle air control motor has no adjustments. It is controlled by the ecm. Also is there any codes.

Posted on May 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Starts but stalls right away


Have you checked your fuel pressure? Could be the fuel pressure regulator. Hard to say without a year and model of the jeep.

Nov 24, 2012 | Cars & Trucks

1 Answer

2006 monte carlo wont start without priming


sounds like your fuel pump weak, need to check fuel pressure when engine won;t start and check with engine running

Sep 03, 2012 | 2006 Chevrolet Monte Carlo

1 Answer

My 1998 Ford Contour will either start or it wont, when it does start it does so just fine, but sometimes it wont prime (it wont make that short whirring sound before you start the engine) and wont start,...


You might want to change the fuel pump Relay. You seem to know when it is getting fuel and when it does not. It is a lot easier to change a Relay than misdiagnose a bad pump. There are several signals which combine to make all the terminals on the fuel Relay switch work. The ignition wire makes the coil inside the Fuel relay connect other terminals. If the contacts are worn out, you can get an intermittent connection.

Next, for how it runs when first started, the brain gets a signal from a water temperature sensor which is an additional sensor than the water gauge. You should notice a higher RPM for a few minutes and then it will drop to normal. This action is the Cold Start Routine. It also makes the fuel mix richer. If the car is missing this routine, the engine can die at idle.

You can get a free scan at Autozone or Oreillys and it may show more details.

Dec 27, 2010 | 1998 Ford Contour

1 Answer

I have a 1989 iroc camero that will not start.it has a throttle body carb and is a 305.the fuel pump works fine.the car will start if you prime it,but otherwise it wont fire at all.it has power on one wire...


Although you Say the Fuel Pump is Fine, What you Discribe is A NO FUEL Problem If it Starts When Priming and Does Not Without Prime this IS a Fuel Pump Problem NOTE: If you HEAR the Fuel Pump this only Indicates that the MOTOR that Drives the Fuel Pump Works , A Fuel Puessure Test Will Determine if your Fuel Pump In FACT DOES Work.

Apr 18, 2010 | 1989 Chevrolet Camaro

1 Answer

1994 sonoma stops running when it warms up


Replace you fuel Injector pump and check for any bad or clogged injectors. make sure idle adjustment screw is properly set 1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Apr 24, 2009 | 1992 GMC Sonoma

1 Answer

1991 Accord keeps dying less than 10 minute of driving


IDLE AIR CONTROL VALVE.....easy fix...controls idle fuel air mixture and if not working car will stall....

Aug 02, 2008 | 1991 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...