Question about Dodge Caravan

1 Answer

Headlights alternate flashing with turn signals even when the ignition is off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 316 Answers

It sounds like you may have a bad ground . Ck the connectors at the head lights both sides make sure they are clean and free of corrotion also if you have a multimeter ck for a ohm reading on the ground wire at the head light connector it should have less then a .5 ( 1/2 ) ohm drop. One wire (black) is the ground , the other two wires are power they will alternate power as you switch from high to low beam.

Posted on May 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My brake lights flash with my turn signals. They also illuminate when I turn the headlights on. And when the headlights are on, they will illuminate with the turn signals and stay on even after I turn


One or both rear light assemblies are not earthing.
You'll probably have to remove them and clean all corrosion or dirt around the mounting bolts.
Alternatively, you can run an earth wire from each light assembly to an earth screw.

Apr 13, 2014 | Jeep Cars & Trucks

1 Answer

No power to car key wont turn


check the alternator and check for a short or ground a wire may be touching the frame you may want to check the engine computer module

Feb 17, 2014 | 2004 Mercedes-Benz S 430

1 Answer

My right turn signal isn't working correctly. When I'm driving down the road my dashboard indicator for my right turn signal will turn solid green but wont flash, But when i turn my...


I had the same problem on a 92 & 95 Dakota years ago, replaced the turn signal switch in the column & found a loose ground wire in the harness back by the tail lights. Never had a problem again. If you're gonna try to replace the switch you will need tamper proof torques bits just FYI. Good luck. Let us know how it turns out.

Nov 07, 2012 | 1995 Dodge Dakota

1 Answer

Left turn signal + headlights


Try turning the 4-way flashers on with the headlights and see if it looks normal or if it looks like they are flashing alternately instead of together. If it looks like they are flashing alternately, you have a bad ground on that bulb. Difficult to explain easily, but bulb grounds through the circuit that is turned off until both circuits are energized, then problems occur. If not, try unplugging the U-Haul harness, they usually are just plug in deals and see if that fixes it.

Nov 25, 2009 | 1998 Nissan Altima

1 Answer

Jeep Wrangler 2006-Front turn signal/yellow light doesn't work.


Check the ground wires at the lights are clean and tight.Its a ground problem you have.

Aug 08, 2009 | 2006 Jeep Wrangler

2 Answers

1994 jeep cherokee headlights on slow turning signals


It sounds like your alternator may be going bad, even if you have it tested it may say it is still good but the regulators in those wont show if it is bad

Feb 01, 2009 | 1994 Jeep Cherokee Country

1 Answer

Electrical problem?


it could be the controller of the lights and not the alternator. but in the first place why did your car got low battery?.. maybe the battery is just old.

anyway, try this solution if it would work. you said you already replaced the battery, now remove the positive cable of the battery, tun on the ignition switch, turn on your headlights, and your ac,

now put the positive cable back to the battery, ( blower would run, lights would come on ) then turn off the ignition switch.

tighten the positive terminal and start the car, let me know what happen?


tnx 4 using fixya,

drcool

Oct 09, 2008 | 2001 Lincoln Continental

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...