Question about 2004 Nissan Titan

1 Answer

I have a 2004 Titan SE and was in the process of picking my daughter up just prior to yesterday's rain storm. While attempting to activate the front d/s power window I heard the mechanism going down, but the glass stayed up, for just a second. Then the glass fell down to bottom of door. If at all possible, I need instructions how to take the door panel off and and how to inspect the regulator cable to see if same is broken. A few years ago I had to change my broken front p/s sideview mirror. I completed the project and the mirror is doing fine. However, the project took a few hours (5hrs) and this was due to the fact that I have very, very limited knowledge of mechanical devices. So please be patient with me. In advance, thank you for any possible resolve to my problem. Best Personal Regards.........John from New Jersey

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 3,645 Answers

Removing the door panel is usually an intuitive process for those used to searching for hidden screws and fixings. A repair manual will be found very useful for most folk. Often some plastic studs will need replacing and sometimes minor repairs will be needed to the inside of the panel after removal. Familiarity and a selection of dedicated tools help prevent this.

Behind the door panel there is the door film which is a damp-proof membrane and is usually firmly glued to the door. This should be replaced if damaged (or repaired) though can usually be removed with patience.

Once the door panel is removed you could encounter an airbag(s), a loudspeaker(s) and a certain amount of electrical wiring. It is usually necessary to move as much as possible in order to view the door internals and window mechanism.

The window mechanism might be a cable type but equally could be a rack and pinion type or a type with one or more levers. Some of the cable types are very complex and some of the other types need careful adjustment after fitting. The glass could be retained to the regulator in a variety of ways.

Good visibility inside the door cavity is difficult so good illumination from a suitable inspection light is a must, preferably in the gloom of a garage or workshop to avoid dark shadows. A non-chattering and obliging assistant is almost a necessity.

When reassembling it is wise to ensure all moving parts are adequately lubricated with appropriate lubricants, depending on the type of regulator.

Posted on Mar 16, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bunnydawg
  • 5158 Answers

SOURCE: 2005 Ford Focus - Mistery Check Engine Light!

check the relays and see if there is one specific to the check engine circuit.... it's sticking on sometimes

Robert

Posted on Feb 24, 2009

  • 42 Answers

SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel

This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal

Posted on Mar 20, 2009

messstat
  • 365 Answers

SOURCE: how do i remove the inside panel of a nissan titan door

Get a 18V drill with phillips screw extention and start buzzing the screws in the armrest and under out...the glass could be anywhere so wear gloves.
Good Luck

Posted on Jun 22, 2009

FixurNissan
  • 61 Answers

SOURCE: left front drivers side power window went down but

Hello and thank you for using FixYa!

Most likely your window regulator cable broke. That is why the glass can not be controlled. You will need to remove it and inspect it to verify.

Thanks Jay!

Posted on Jul 17, 2009

  • 60 Answers

SOURCE: Non working driver side power window 2003 Nissan Sentra

I had a similar problem, window fell down one day while driving. Screw was loose at bottom of window that connects to track. Was hard but fixed it and worked great after. Hope it helps u out.

Posted on Aug 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn on the air bag passages side light says that the air bag is off want to turn on 2004Nissan titan


The passenger side airbag does not have a switch that you, as the operator, can turn on or off. There are sensors in the seat and seat belt system that determine when the passenger side airbag should be activated. Attached is a link to the owners manual for your vehicle. Check pages 1-20 and 1-21 for details.

http://www.courtesyparts.com/pdf/2004-Nissan-Titan.pdf

Jan 16, 2015 | 2004 Nissan Titan

1 Answer

I need the wiring diagram for a 2010 nissan titan se mass airflow sensor


I bet your RPM wont go over 2500 or 3500 when you kick it down <dont waste your time with air flow sensors or O2 sensors ,it's 100 % the fuel pump ,i replace almost everything it turns out the fuel pump was faulty

Sep 19, 2013 | 2004 Nissan Titan

2 Answers

How many quarts of transmission fluid does a 2004 yukon hold


Ya. We had the oil shop change fluid $150. (force flushed). They under filled it by a 1 qt 1/2.
Then my son over filled it. Tranny died 4 months later.
Prior to that he drove in a rain storm flood and the nissan has a rediculas air intake dpwn by bumper caused water into cylinders. By a miracle the engine stoped but did not break internally.
Hate the industry. .

May 05, 2013 | Cars & Trucks

1 Answer

Why does my nissan Titan **** in overdrive especially when I'm going up hill


Be more specific with details- with load, with no load, does not matter what load, etc, does it die? does it stumble? does it slowly lose power?

Without that information it could range of just about everything from a restricted/plugged exhaust to inadequate fuel pressure, and then some.

You could try backflushing the Mass Aie Flow sensor with contact cleaner as well as the TPS. And start it up at night in the dark and look for arcing of ignition components.

If no codes have tripped yet, this might address the issues prior to an error code being logged.

May 03, 2012 | 2004 Nissan Titan

2 Answers

Bought a used 2006 Nissan Titan with a 1 year old Continental battery. Drove it for 4 days, was cleaning it out with all windows down and doors open. Tried to crank it. Wouldn't start and wouldn;t allow...


2006 NISSAN TITAN ELECTRICAL SYSTEM:BATTERY
Occurences: 1 NISSAN NORTH AMERICA, INC.
Recived: 2007-09-20 Summary: 2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY... The following ELECTRICAL SYSTEM:BATTERY complaint about 2006 NISSAN TITAN was reported to the National Highway Traffic Safety administration on 2007-09-20. For more information contact the National Highway Traffic Safety administration or the US Department of Transportation. See complaint summary below.

Build Years/Makes/Models: 2006 NISSAN TITAN
Occurances:
Reference Number: 10203844
Summary: 2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY SHOULD LAST MORE THAN 11 MONTHS. *JB
Build Years/Makes/Models: 2006 NISSAN TITAN
Occurances:
Reference Number: 10203844
Summary: 2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY SHOULD LAST MORE THAN 11 MONTHS. *JB


2006 NISSAN TITAN
Occurances:
Reference Number: 10203844
Summary: 2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY SHOULD LAST MORE THAN 11 MONTHS. *JB
2006 NISSAN TITAN
Occurances:
Reference Number: 10203844
Summary: 2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY SHOULD LAST MORE THAN 11 MONTHS. *JB
2006 NISSAN TITAN BATTERY DIED WHILE DRIVING. CUSTOMER STATED THAT HE HAD NO PRIOR INDICATIONS BEFORE THE FAILURE. HE ASKED TO BE REIMBURSED FOR THE BATTERY . *KB THE CONSUMER STATED A BATTERY SHOULD LAST MORE THAN 11 MONTHS. *JB
CHECK WITH ANY DEALERSHIP AND GIVE THEM THE VIN NUMBER AND ASK IF THERE ARE ANY TSB'S FOR THIS VEHICLE IF THERE ARE THERE WILL BE FIXED AT NO COST TO YOU

Apr 14, 2011 | 2006 Nissan Titan

1 Answer

My 316 i se, 1999, 1895cc, have a problem with the window wipers, they wont work in the rain and in the dry work for five mins before they fail ???


the wiper motor is going out have it fix befor you get cought in a big rain storm with no wipers.i had the same problem.also check to see if water is geting inside the motor ok

Aug 24, 2010 | 1996 BMW 318

1 Answer

My 2007 titan window on the passenger side was left down about 7 inches in the rain. Can I disconnect the air bag and remove the seat?


you can make sure to disconnect the battary for at least ten mins prior to disconnecting the airbag harness which is yellow to prevent airbag codes from being set make sure you have the key in the off position unitl you have the seat all plugged back up

Mar 21, 2010 | 2007 Nissan Titan LE

Not finding what you are looking for?
2004 Nissan Titan Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...