Question about 1995 Geo Tracker

1 Answer

1995 Geo Tracker 4x4 Heating and cooling cable came loose from the bracket. What is the best way to resecure the cable?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,044 Answers

There should be a bracket that has either lost a bolt or has broken. You have 3 choices essentially. Try repairing the bracket, if it's broken, using something like J-B weld available at most parts stores. This will not work too good on Aluminum in most cases. Use a zip tie or wire to secure the cable, which is most likely the best choice, or replace the cable. If your talking about the cable that controls hot or cold settings that is a different story. That has connectors on each end of the cable and if those break off then you have replace the whole cable. Most likely cost about $20.

Posted on May 19, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to torch the hub on a 92 geo tracker 4x4


torch?
you mean TEST?
HUB the front bearing hub or the axle end locking hubs.?????
auto or manual hubs>?

test
http://www.suzukicarparts.com/parts/1995/Suzuki/Sidekick/JLX/index.cfm?siteid=214820

fix hubs

http://www.fixkick.com/hubs/hubs.html

Sep 28, 2014 | 1992 Geo Tracker

1 Answer

Rpm gage flickering,radio.heater fan all die while driving?


Have you had the charging system tested, it may be low voltage that is causing this or a defective battery connection due to corrosion or a loose cable or both.

Feb 10, 2012 | 1992 Geo Tracker

1 Answer

WHAT IS THE FUNCTION OF THE CABLE THAT GOES INTO THE REAR END OF A 1995 GEO TRACKER 4x4.


I have the same problem few days ago, and still didn't find any solution. Can any one please help?????4

Jul 28, 2011 | Geo Tracker Cars & Trucks

1 Answer

1995 4x4 geo tracker front wheel bearings


first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.

May 05, 2010 | 1995 Geo Tracker

1 Answer

How do i replace a water pump on a 1993 geo


1 disconnect battery ground cable
2 drain cooling system
3 on models with a/c, proceed as follows:

a discharge a/c system
b loosen upper and lower compressor bolts and remove compressor drive belt
c remove a/c line from top of radiator shroud

4 remove water pump drive belt
5 remove reservoir tank from radiator bracket
6 remove radiator shroud and fan/clutch from vehicle
7 remove waterpump pulley from waterpump
8 remove timing tensioner and timing belt
9 remove dipstick tube
10 remove alternator mounting bracket at water pump
11 remove water pump mounting bolts and water pump
12 reverse procedure to install, using new gasket and rubber seal

Feb 18, 2010 | 1993 Geo Tracker

1 Answer

I'm trying to remove the bezel around the radio, heater, vents without destroying it, 1995 Geo Tracker. Thank you


Most bezels just snap on and off using clips. Just use an auto trim staple puller (which resembles a small button popper tool) and insert it in and around the bezel and gently pry until you pop loose one of the clips, then work your way around the bezel until all the clips are loose.

Aug 16, 2009 | 1995 Geo Tracker

3 Answers

Took over a 95 geo tracker project car. alot of mhands in there before me. haveing problems with the clutch cable linkage under the dash. either somethings missing or has wrong parts on it. do you have a...


the cable just hooks over the top of the clutch pedal.
Google Clutch cable and you will get an automotive site.
Select Tracker and you should pull up a picture.
There is very little to it.
The cable comes through the firewall and hooks on the top of the clutch pedal.
Hope that helps



Jul 17, 2009 | 1995 Geo Tracker

1 Answer

94 & 95 Geo Tracker obd1 cable


you need the same brand cable.

Apr 03, 2009 | 1995 Geo Tracker

Not finding what you are looking for?
1995 Geo Tracker Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...