Question about 2005 Ford Expedition

1 Answer

L am getting check electronic throtile control then shutoff the car and i check it in my work shop and replace many things ( senser & filters extra. ) but still same problem what is the reson please

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Your electronic throttle body is bad, this is a very common problem on these cars. Replace throttle body and then if you have scanner clear codes, if you dont have a scanner disconnect your battery for 10 to 20 minutes to reset

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

20069 buick rainier shutoff off while driving


That could be a tough one to diagnose even with the proper diagnostic tools . Your best would be to take your vehicle to a qualified repair shop to have it checked ! You don't want listen to people on here saying it's this or that and just replacing parts that don't fix it . With all the electronics on your vehicle this problem could be a lot of thing's . And with out testing and knowing for sure I wouldn't even say it's one thing or another .

Dec 15, 2016 | 2006 Buick Rainier

1 Answer

My 1994 chevy 1500 wont shift into 3rd, like nothing there. Computer,trans senser, speed controller replaced, any ideas


First thing that comes to mind is the shift solenoid. I would take it into a tranny shop and have them evaluate it for you. It is only about 90 bucks. Then you can decide weather or not to attack it yourself.

Dec 08, 2015 | Cars & Trucks

1 Answer

How do i know if i need a speed senser or a input senser


You need professional test equipment
on the vehicle & road test
Have a Trans,Repair or Dealer work on that issue

Jul 26, 2013 | Cars & Trucks

1 Answer

Code P0170 and P0173


The shop failed to do basic preventative maintenance
such as scan the systems,look at data & possibly road test
The vehicle is a 2000 year you ask about oxygen sensors
& when they were replaced & look at mileage They get changed
at 100,000 miles
You got idle issues
What happened there? They let that go also
Google any codes you get
OBD PO171 etc
I would find a different shop
Tune-Up is no more than spark plugs & that
is preventative maintenance
You don't do a tune-up for a problem
You do spark plugs every 3 years & then you know
when they were done last & proceed to diagnose the
drivabelity issues
These shops will do & sell what ever you ask & then some
to stay in business
They fail to really check your vehicle over completely
you can't install spark plugs & throw on wires you don't need
& expect that to do a thing as far as knowing how the vehicle
is operating.there electronically controlled & need those systems also

Jul 22, 2013 | Mitsubishi Cars & Trucks

1 Answer

Hi gentlemen , would you please help me for


This issue usually occurs when the vehicle is between 60 - 70 mph. There is no official solution to this issue, it should have been a Ford recall, as this fault is dangerous.

There is a known malfunction in the fly by wire system that is suspected to be the cause of this system failure. The throttle body assembly gets replaced when this occurs as a possible solution to the problem. Check the connections on the 2 tps sensors first before assuming the replacement is necessary.

May 20, 2011 | 2006 Ford Expedition

1 Answer

Speed sensor failed. can i replace it


Sure you can if a mechanic can do it so can you if you have the right tools and knowlege. First you need to know which one thers's one at each whell at the fround rear end housingf the rear rear end housing and the one in the side of the transfer case where the speedometer cable would'of connected on an older model and then theors three in the sides of the trans mission, Touque converter speed forward turbine speed output turbine speed. What proble are you trying to fix? the speedometer not working? Abs light on? Cheack engine light on? Cruise control not working? If the cruise control does work the speed senser is good and the check engine light will be on if the speed senser is'nt working. If the speed senser is'nt working the car will only take off in low and not shift to seecond or any higher gear as the computer doesn't know how fast the car is going. If the speedometer is'nt working and it does shift and cruise and the check engine light is'nt on then the speed senser is working but the speedometer is'nt if it is'nt and everything else is woring then as your driving hit the speedometer with your fist and see if it comes back on they can get stuck and i've fixed quite a few and they stayed fixed. On to wheel drive models with the rear wheels jacked off the ground safty I've run the car up to speed and trying wiggleing the wires and connectors till I wiggled the right thing till the speedometer came on ( including smacking the speedometer ) Just don't hit it too hard as it'll bust just like anything else.

Dec 21, 2010 | 2005 Jeep Liberty

1 Answer

Engine light suddenly on during inspection!!


it is not a fuse it is not caused by the shop, u have a fault in the electronic engine or emission controls, that is the only thing that turns on the check engine light.

Oct 28, 2009 | 1995 Lexus LS 400

1 Answer

2000 Silverado-4.3 ltre-cranks over-wont start-consistenly puts out P1351 code-crank senser,cam senser, ignition control module, spark plugs and distributor have been replaced. Wiring from PCM to crank...


Yes. First, in the fuse block under the hood check INJ A fuse and INJ B fuse. INJ A fuse is circuit 1039 which feeds the coil. If the fuse is OK, replace the coil electrical connector. I stock 2 of these at my dealership because they are needed quite often.
FYI P1351 is an ignition coil control circuit DTC.

Aug 30, 2009 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Replace my control remote for my ignition started & alarm system


there should be a button some where that you can push while the key is in the on position and it will stop the alarm for that ignition cycle. Then i reccomend taking the alarm out or take it to a reputable electronics shop and they can tell you what manufacture and model is.

Jul 28, 2009 | Mitsubishi Lancer Cars & Trucks

1 Answer

No take off power


I had the same thing it was a bad ground under the fuse box and a mix of bad wires and disturber.

Jul 03, 2008 | 1996 Dodge Dakota

Not finding what you are looking for?
2005 Ford Expedition Logo

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...