Question about 2004 Mitsubishi Endeavor

1 Answer

I have a 2004 mitsubishi endeavor and when i use the a/c the floor on the driver side gets soaked how can i fix it without taking it to a dealer.....

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 29 Answers

The evaperator drain is cloged

Posted on May 18, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Our 2004 Mitsubishi Endeavor continues to leak water in the driver's floor board and you hear it splashing in the compartment. We have had it reparied two times. And it works for awhile and then ret


You most likely have a leak in the heater core.
It will have to be removed , repaired or replaced.

Any independent garage can handle the job.

Jun 02, 2014 | 2004 Mitsubishi Endeavor

1 Answer

Soaked carpet floor on drivers side. First was told it was air conditioner then something on heating. it is not under warranty any longer.


put your hand on it and rub a bit. if it is slippery and sweet stinky it is anti-freeze and your heater core is leaking. the engine is also tending to run hot as needed coolant is inside the car on the floor instead of inside the cooling jacket. you are going to need a real mechanic to swap in a new core.

if it is not slippery and stinky then the drain for a/c condensation is plugged up. take it to a muffler or quickie oil change shop and ask them to clean out the drain for you. takes but a few minutes and a few bucks, maybe even free if you get your car lubed at the same time.

May 16, 2011 | 2004 Mitsubishi Endeavor

2 Answers

Mitsubishi Endeavor 2004. 1. the tail gate and the tail gate glass do not open 2. the AC drains into the driver flooring instead of draining outside to the ground. Why? And where is the output drain...


The door and the glass just needs some penetrating lubricant( WD 40 ), just a few squirt will do on hinges and locks!
The drainage hose would be under the passenger side( RiGHT FRONT SiDE) glove box, look down there, u will see a black hose from the center that houses ur A/C & heater housing! Lift up ur floor covering to see it clearly. check and clean the hose it might already been clogged by moss and dirt or dislocated thru the drain holes on the flooring! Hope that helps out! Taah!

Nov 18, 2010 | 2004 Mitsubishi Endeavor

1 Answer

2004 mitsubishi endeavor where is drainage tube located, condensate is leaking into driver floor compartment?


do you have a sunroof?

if not is your heater working? busted heater matrix otherwise

drainage tube should be located behind the drivers side kick panel

Sep 18, 2010 | 2004 Mitsubishi Endeavor

1 Answer

AC drained into blower motor...replaced moter and now wont work


Did you check the blower motor before installation?Check for a blown fuse,and a bad relay,also check the blower motor resister.I hope this was some help.

Oct 05, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Water on driver side leaking from a/c.


you have to take it to the dealer ship because if you start taking it to any other than the dealership you will never get it fix ....they have to take the whole dash off then work from thier ....believe me i went tru a night mare.......

May 02, 2009 | 2004 Mitsubishi Endeavor

1 Answer

2004 endeavor problem


Souns like a leak is allowing water into the cabin area, there may have been a leak in the firewall but it looks like it's coming in from somewhere else. Take a look at the rubber door seal in the drivers side door jam and check it for damage or possibile leak area's, if you find a leak here it can be sealed with silicone or you can replace the entire dorr seal. The only other possibility for the leak would be the seal around the windshield, also check this and seal with silicone if a leak is deteteced.

Hope this helps

Sep 13, 2008 | 2004 Mitsubishi Endeavor

1 Answer

2004 endeavor


Remove Endeavor Rear Panel

On the side panel there is a cargo hook with a 10mm bolt. Take that bolt out. On the floor panel there are 2 cargo hooks -- also 10mm. Take them out and remove floor panel. Fold seat forward and you should have access to 5 or 6 bolts -- also 10mm. Remove them then pull the panel out slightly and disconnect the cig ligthter and that should solve your issue.

Jun 21, 2008 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

Related Topics:

344 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...