SOURCE: change oil light remains on
To reset the Change Oil Light:
Open driver's door and open fuse access panel
Turn ignition key to on (don't crank the starter)
Push reset button located in fuse panel
When Change Oil Light starts to flash
Press and hold reset button until it beeps and light goes off
Repace panel
SOURCE: how do you change the license plate light bulb
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
SOURCE: 2006 Kia Sorento Brake Lights not working
Apparently this is a recall matter and will be fixed at no charge. KIA Consumer Assistance Center 1-800-333-4542. Recall notices were to go out in May/June 2009.
SOURCE: 2006 kia sorento
I have a 2006 Sorento wtih th same headlight problem. And it's not that any of us are touching the bulb or is it moisture because too many of us have this problem. My buddy thinks it's the wiring. The way the wires run to the headlights, they are near warm things in the engine. When the wires get hot, the bulb thinks it's hotter so it's life span isn't as long. What needs to be done is to insulate the wiring. I have tried this and it seems to be working so far.
Welcome to FIxYa.com
Depending on which one check the voltage to the bulb if ok replace socket. Could be shorting out
Thank you for using FixYa.com
Regards, Lee Davidian
1,059 views
Usually answered in minutes!
×