Question about Chrysler Cirrus

1 Answer

Why does the word door come on when you move the car

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,400 Answers

Possible a door is not shut tight.Check the trunk too.

Posted on May 18, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just replaced a a/c heater blower motor resistor and now I have hot air on drivers side and cold air on passengers side and in the rear. .


Sounds like driver side blend door is not functioning, either actuator bad or door has broken, remove actuator see if door moves freely, if door moves freely test actuator, leave out and connect wiring, move controls from cold to hot see if actuator moves.

Apr 23, 2015 | Cars & Trucks

1 Answer

How to adjust rear doors onhj75 troopy


the door hinges move in or out to adjust that side of the door and the door lock latch moves to adjust that side.. loosen the door hinges just enough to move the door then -tension them to see how you are going. With the door open and the bolts slightly loose it may be possible to move the hinges by placing a long bar on the hinge past the door edge and hitting with a hammer

Jun 26, 2013 | Cars & Trucks

1 Answer

What does it mean when the car door wont shut?


Youre door is probably bent at the door hinges. You need to adjust the latch bar on the door jam. There will be two bolts to loose and you can move the bar in all directions. You probably need to move it down.

Jul 26, 2012 | 1995 GMC Safari

1 Answer

1998 blazer heat works great but defrost doesnt, could there be a blocked hose and how do i check?the defrost at the front wont blow.


if you have heat and nothing blows on defrost then this is a mode door problem that is not changing from floor to vent to defrost mode.it could be the mode switch or the mode door not working.the mode door is on the air duct under the dash and you can manually move it when you disconnect the control with your hand it should move freely.some of these have a small motor that moves the door.and if you move the switch in different modes or better have someone move the switch while you see were the door is the one that is moving is the mode door.if it won`t move on defrost tap the motor and see if it starts to work.if it does then it will have to be replaced if not it could be a switch problem.

Oct 26, 2011 | 1998 Chevrolet Blazer

1 Answer

My heat works on passenger side but not on my driver side nor defrost, which blows out cold air


Back behind and under the dash panel is a venting system. In the venting, there are blender doors. These doors move to different positions for different air flow directions. These doors are moved by acutators. These doors can get stuck! The actuators that move them can also become faulty but not as common as the door getting stuck. The worst part is removing all the venting to get to the blending door.

Nov 08, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

My driver's door have to be slammed very hard for door to close all the way


There is a pin that the door catches on to stay closed. This pin is located inside the door jamb. It may have become loose and moved. Or your door hinges could have become loose, throwing this alignment off, as well.

Chances are that the pin became loose and moved a little farther inside, toward the car's interior. This pin needs to be loosened up, then moved back outward just slightly, then retightened. Check by closing door.
Recheck, readjust if necessary.

Hope this helps.

Dec 18, 2009 | 1993 GMC Suburban

1 Answer

While the back door was open I moved the plastec lock mechanism inside the car. Now I can't move it back and I can't close the door.


when its closed the door hinge stops it from moving too far because it gets wedged and jambs. take a large screw driver and use a hammer to knock it back into place

Nov 30, 2008 | Subaru Outback Cars & Trucks

1 Answer

1997 Toyota Rav4 doors are locked


over time the grease in the locks etc can become frozen and stop movement when its warmed up a bit it will move better, using the key on the doors every now and then helps move this greas about as the central locking wont move these parts only the switches, replacing the grease after a degreasing locking mechanisms inside the door on the rear of the lock should help choose a grease that can handle low temperatures.

Jun 07, 2017 | 1997 Toyota RAV4

2 Answers

Seat belt does not move when i opn the door


If only one seat belt does not move when you open door then check the pink wire in the rubber boot passing from the door panel to the cabin around the door hinge, however if it is both seat belts that don't move when their respective doors are opened, the problem is in a little box located right under the hand brake lever, behind the shift lever, of course you have to remove some of the decor to get to it.

Oct 30, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...