Question about Chevrolet HHR

1 Answer

Bumping under front when darting side to side

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 338 Answers

Either ball joints or struts are worn

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dipping front end


You have worn parts, what those may be requires a skilled front end tech to find.

Aug 30, 2012 | Cars & Trucks

1 Answer

HOW TO INSTALL 05017800AA KIT


remove oil pressure switch connector,remove sealing dart from the empty cavity at rear of connector, pull terminal locking ring out from front (switch) side of connector to gain access to terminal locking tabs, install wire terminal vent part# 05017800aa in place of the removed sealing dart, slide locking ring back into place, attatch commector to switch

Aug 13, 2012 | 2001 Chrysler Sebring

1 Answer

At every bump or rut in the road the truck darts one way or the other. I am having to saw at the wheel left and right to try and go straight. front tires are wearing out very fast. I was told that I need...


if you installed bigger tires not the factory tire recommended then you need some additional sway bar support. otherwise you are driving wiith a bit woobling.......

Jan 09, 2011 | Dodge Ram Pickup 2500 Cars & Trucks

1 Answer

Everytime I hit a bump I hear a clunk in the front end of my 2003 ford f250 superduty. I've changed all ball joints, the tie rod attached to the pitman arm. It also has unstability in the steering. It...


I'd be inclined to check the suspension. Jack vehicle up so wheels hang free & check the mountings, springs/shock absorbers, & sway bar.
Also 'bounce' the vehicle at each corner in case a shockie has internal problems,


May 27, 2010 | 2002 Ford F250 Super Duty SuperCab

2 Answers

Front driver side suspension knock over bumps


See if you can bounce car and replicate the noise. If you can, you should be able to find it, and put your hand on it. Stabilizer bushing are a place to look, both at the lower a arm and on the frame. If you narrow it down to the strut, it will need to be replaced. The front trans mount also goes bad, try putting it in drive with your foot on the brake and give it some gas and see if the engine moves an excessive amount.

Nov 23, 2009 | 1992 Buick Regal

1 Answer

1969 dart, front end vibrates at about 35 mph, had new tires put on and are balanced. What else?


You should take the car back to the tire shop and ask them to check the tires again for balance and also check the front end under the car. I have a 71 Dart and if things get a little loose in the front end it creates a vibration. Also are the shocks good? Bad shocks will allow the front end to vibrate as well. And if there is something wrong with the front end it can be dangerous. I hope that this helps. let me know. Please leave feed back.

Jun 22, 2009 | 2006 Dodge Ram 1500

1 Answer

Clunking noise while turning/hitting bumps


Hay I would check your sway bar in the front .The bal may have came out of the seat located under front wheel well. Also they could be just loose. Check by rocking your jeep side to side .

Sep 15, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...