Question about 2000 Chrysler Grand Voyager
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
In 2000 the only Grand Voyager that was equiped with a cabin air filter was the 6 cylinder 3.3 liter Sport model.
Cabin filters are generally found in one of two locations: under the hood, or under the dash board.
Posted on Jan 10, 2009
http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=CHRYSLER&model=TOWN%20%26% The Town and Country has the Exact same Motor, Here is the Link to the 3.3 Liter Belt Diagram. It is the First at the Top, Just read the Header. Please Rate My Response! Thanks!4ZYEV3
Posted on Feb 06, 2009
SOURCE: blower resistor
In the manual I have it is shown to be located under the hood at the rear of the compartment on the firewall area where there are several rectangular openings. The block is hidden from view below the wiper module on the lower edge of one of those openings. It has a 5 wire plug on the cabin side of the the opening. If you don't find it, then I know in the 2001 model it was in the cabin, behind the glove box again with the resistors sticking thru the firewall where the air intake would cool them. I just don't know in what year the block was moved between '98 and '01
If you find it in the first location you use a couple of flat blade screwdrivers to release the block and pull it into the engine compartment. On the hidden side push on a spring tang on the driver's side narrow edge of the block and on the comparment side you will see a couple of etched lines on that same side showing where to put the tip of the other screwdriver to pry it forward into the compartment.
Get a replacement block and install making sure the resistors aren't touching one another. If you have trouble removing it I can send you a page that shows what I described above. PS Please let me know where you find the resistor block to be located. Use the 'thank and rate' tab to get back to me quickly without having to wait for me to be "available"
Posted on Apr 13, 2009
If it's in limp mode, the check engine light is on steady, or blinking, or a combination of the two. You need to have trouble codes read, most parts stores offer this as a free service. They will plug a hand held scan tool into the vans diagnostic port under the dash, and 'read' codes stored in the computer. They can explain what they mean, and make recommendations on what to do to fix it. If you have any questions after that, post them here with the code #'s.
Posted on Apr 18, 2009
use a lift, let van cool or change front three while van is cooling and from the under side of the engine change the other last three. They can be reached easily. No need to remove plenium.
Posted on Jul 08, 2009
Tips for a great answer:
Dec 31, 2013 | 2000 Chrysler Grand Voyager
Sep 08, 2012 | 2000 Chrysler Grand Voyager
May 18, 2017 | 2000 Chrysler Grand Voyager
Dec 02, 2010 | 2000 Chrysler Grand Voyager
Oct 08, 2010 | 2000 Chrysler Grand Voyager
Feb 18, 2010 | 2000 Chrysler Grand Voyager
Jul 20, 2009 | 2000 Chrysler Grand Voyager
Apr 04, 2009 | 2000 Chrysler Grand Voyager
51 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: