Question about 2006 Toyota Land Cruiser

1 Answer

When driving engine oil light is switched on - 2006 Toyota Land Cruiser

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Look in your owners manual if it is still there and there is a procedure that takes a couple of minutes to turn the light off .Also this is a good basic guide for most dash light related information.Thank you for your questions.

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I experienced twice an orange engine oil pressure warning light and after the car wont move. I switched off the car and after ten minutes it moved. what is the problem


While an electrical fault or a faulty switch could put the light on, it is such an important light it should never be ignored and the reason for it established immediately. As far as the owner is concerned that means lifting the bonnet and checking the oil level and adding more if the level is low. If it isn't low the car should be recovered to a repair shop. Driving further could be very expensive and very inconvenient...

If the oil pressure light has switched on because the oil pressure is low then continuing to drive will soon wreck the crankshaft bearings or cause crankshaft or camshaft seizure. Damage happens so quickly if the oil pressure is lost at motorway speeds the engine is likely to be severely damaged by the time the car is stopped.

I strongly suggest you have the reason for the light switching on established and repaired.

Apr 12, 2016 | Cars & Trucks

1 Answer

Exclamation with oil can on dash


Loss of oil pressure/ low oil. DO NOT drive the car until it can be verified that you have oil. If that light is driven off a pressure switch, and the switch is bad, then the light is giving a false indication and the switch should be replaced. If you've lost oil from a leak somewhere, you could easily and quickly destroy your engine if you keep driving it.

Apr 10, 2014 | Honda Cars & Trucks

2 Answers

Hi, My oil light came on this morning, I freaked. I only got out about 200 ft when this occurred, so i drove it back in and plugged it back in due to the cold weather where I live. Why would the oil...


the first thing that you should do when a light comes on is the check the item that the light is warning about, the OIL LEVEL. if is low, add to the full mark, and find out why its low. Do not drive the car 10 feet with the oil light on. check the oil level ASAP.

Dec 13, 2010 | 2005 Toyota Corolla

1 Answer

The RED LIGHT low oil pressure comes on and off The dash board display flashes STOP,The engines full of clean oil at the right level. how can i test the oil pressure??? do i have to the engine...


DO NOT DRIVE IT.try an oil pressure switch first and if no better,worry,the minimum will be a new oil pump....(if you drive it and it is the pump, you will need a new engine.....)

Sep 18, 2010 | Volkswagen Passat Cars & Trucks

1 Answer

Just purchased a 04 Chrysler Sebring 2.4L Conv. 2 wks ago. The very next day when I was driving it when I would come to a stop light the car would start idling really low and acted like it was going to...


This fix works for 2.7L engine. Worth having your mechanic look at.

Answer
NO: 08-36-99
SUBJECT: Engine Oil Pressure Light Flicker
DATE: Oct. 15, 1999
OVERVIEW:
This bulletin involves adding a terminal/wire/vent to the oil pressure switch connector.

NOTE: THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 2.7L ENGINE.

SYMPTOM/CONDITION:
With a hot engine the oil pressure light may be on or flicker on at idle.

DIAGNOSIS:
Verify engine oil pressure as described on page 9-21 of the 1999 Concorde/Intrepid/LHS/300M service manual (Publication No. 81-270-9140). If engine oil pressure is within specification perform the Repair Procedure.

PARTS REQUIRED:
Qty Part No. Description
1 05017800AA Wire Terminal/Vent


REPAIR PROCEDURE:
Raise vehicle on a suitable hoist.
Remove engine oil pressure switch connector from switch.
Remove sealing dart from the empty cavity at the rear of the connector.
Pull terminal locking ring outward from front (switch) side of connector to gain access to terminal locking tabs.
Install wire terminal/vent, p/n 05017800AA, in place of the removed sealing dart. Slide locking ring back into place.
Attach the connector back on the oil pressure switch.
Spot tape the wire/vent to follow the harness towards the top of the engine compartment.

Aug 31, 2010 | 2004 Chrysler Sebring

3 Answers

Oil light on when oil is full


a loose connection WILL NOT cause flickering oil light unless your your oil is empty at the same time a connector is loose. This flickering is most likely caused by clogged oil ports or failing oil pump. When this happens there is insufficient oil running through the engine, causing the sensor to activate the light intermittedly. Have this checked immediately to prevent extensive engine damage. Hopefully this helps!!

Mar 20, 2010 | 1998 Toyota Camry

1 Answer

Oil can icon on the dashboard of chrysler 300 -what to do??


oil light indicates one of two things, Low oil pressure. or Low oil level. Check the level on the dipstick (consult owners manual), if it is low fill it to the "full" line with fresh oil of the correct grade. Also the oil on the disptick should look syrupy golden, not black and dirty - if the oil looks filthy then get it changed, old oil is thinner and results in lower pressure... if it is already at or near the FULL line then you have a more serious problem - low oil pressure is caused by a, faulty oil pump b, worn engine c, wrong grade of oil d, not enough oil e, contaminated oil Also a faulty oil pressure switch could bring the light on... so check this before you have the engine stripped!!!!!
An oil change will cost very little money and could solve the problem, if the light is still on with new oil then chave the oil pressure switch tested... if not the switch than it is a "real" engine problem and needs proper investigation.
IT IS NOT A GOOD IDEA TO DRIVE WITH THE OIL LIGHT ON Unless you know it is an electrical fault and not truly a low oil pressure condition bringing on the light.

CHECK OIL - fill if necesary - light hopefully goes off... STILL ON - have switch tested - switch is hopefully faulty - replace it... STILL ON - have engine checked out - it is losing pressure somewhere
-----------------------------------------------------------

Jan 16, 2010 | 2005 Chrysler 300

1 Answer

How do I change the oil pressure switch properly?


remove oil from engine.unplug connector.clean connector.remove switch.put new swtich.connect the connector.put oil in engine.drive for 10km and check if oil light comes on.

Oct 04, 2009 | 1990 Buick LeSabre

2 Answers

Oil light


If the oil light is on it's one of 2 things: You have no oil pressure, or the sending unit (also known as the oil pressure switch) is defective and is reading no pressure when there actually is normal pressure. You should always assume it means no pressure, because driving it this way will ruin the engine.

Mar 19, 2009 | 2000 Chevrolet Venture

4 Answers

2002 audi a4 oil light issue


There are potentially two different problems here.
1. A fault with the actual oil pressure.
2. An electrical fault with the switching circuit.

If you are confident the problem is not with the oil pressure, disconnect the wiring from the switch for a period of time. If the light still comes on periodically the fault must be with the wiring circuit shorting to earth. There will be no fire hazard to this approach as the voltage will drop over dash lamp.

However if the problem is with the oil supply system, the danger with this approach is you are potentially unaware of a serious problem

Such as the oil filter collapsed or the oil pressure release spring could be jammed open/closed which would cause the engine to not have the correct operating pressure.

Feb 22, 2009 | 2002 Audi A4

Not finding what you are looking for?
2006 Toyota Land Cruiser Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...