Question about Ford Focus

1 Answer

Heater not working only blowing out cold airall pipes are warm

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,129 Answers

Chek the water flow lines from the engine, perhaps a block on the line or a fault in the valve that does not open when the heater is selected can also cause the issue.
You will need to check on the flow pipe to confirm, check the panel controls for activation of the heater.

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 honda civic is not producing heat only blowing cold air


Check that the heater pipe are hot, there are 2 pipes 1 in and 1 out. if both cold could be stat .If 1 is hot and the other is cold it could be air or blocked heater matrix, with car running take cold pipe off . if water flows out check its warm, if it flows out cold leave till water warms up then put pipe back on, make sure you keep radiator topped up while your doing it, if no water comes out when you take the pipe off the matrix is blocked, take both hoses of and flush through with a hose pipe.

Jan 25, 2014 | 2005 Honda Civic

1 Answer

Heater doesnt work


To troubleshoot this types of problem,click the link below :---
Car heater blowing warm, but not hot air?http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html

--------
Engine Overheats and heater blowing cold?

http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html

---------
Heat blows cold on drivers side and hot on passenger side?

http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html

-----------
No heat on car? http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html

------------
Heater blows intermittently and temp gauge goes erratic?

http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html

------------
Heater blows cold?

http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html

---------
Heater/AC blower motor not working?

http://technoanswers.blogspot.in/2012/02/heaterac-blower-motor-not-working-on.html

------------
A/C, heater, defroster fan, not working? http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html Heater problem?

http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html

---------

This will help.Thanks.

Mar 27, 2012 | 1994 Volvo 960

1 Answer

My heater is not working except on one side in my 2007 impala driver side it blows warm passenger cold


To troubleshoot this types of problem,click the link below :----http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html
--------Go through the procedure to confirm the issue.

------
Engine Overheats and heater blowing cold?

http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html

---------
Heat blows cold on drivers side and hot on passenger side?

http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html

-----------

No heat on car? http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html

------------
Heater blows intermittently and temp gauge goes erratic? http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html------------Heater blows cold? http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
---------Car heater blowing warm, but not hot air? http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html-------- Heater/AC blower motor not working?

http://technoanswers.blogspot.in/2012/02/heaterac-blower-motor-not-working-on.html

------------
A/C, heater, defroster fan, not working? http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html Heater problem? http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html---------

This will help.Thanks.

Feb 27, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Air works great but no heat just blows cold air


For this types of problem,i suggest you to check this help links:----Car heater blowing warm, but not hot air?http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html
---------A/C, heater, defroster fan, not working?http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html
--------Heater problem?http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html
---------Engine Overheats and heater blowing cold?http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html
-----------Heat blows cold on drivers side and hot on passenger side?http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html----------------This will help.Thanks.

Sep 05, 2011 | 2007 Suzuki SX4

3 Answers

Heater does not get warm air


Check your anti-freeze level. 9 out of 10 times, it's just low on antifreeze. Your heater takes the heat from the warmed antifreeze,once the engine is warm, and blows the heat off and into the car. If the anti-freeze is low or the motor is cold you wont have heat.

Nov 20, 2009 | 2000 Ford Focus

1 Answer

Heating problem driver side blowing hot air passanger side blcold


its likley to be the pipe has been riped off or fell off or its the flaps on the heater box its self not opening,,,have a look under the dash to fine any pipes that are off the heater box,,
anyhow, who cears if the passanger gets cold,,, its the driver who needs to keep warm!!!!
unless its the other half? or worse still its the mother in law!!!! ho ho ho!

Nov 05, 2009 | 1995 Oldsmobile Ninety Eight

1 Answer

No heat air is blowing cold


First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced.
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is worm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest to flush the heater core.

Oct 22, 2009 | 1998 Ford Taurus

1 Answer

MY 1998 FOR TARUS HEATER WILL NOT WORK.WAS DRIVING


It is most probably the problem with blend door or blend door actuator. But just in case I would suggest to follow the entire procedure:

First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is warm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest flushing the heater core.

Oct 17, 2009 | 1998 Ford Taurus

1 Answer

Heater not working


First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced.
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is warm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest flushing the heater core.

Oct 17, 2009 | 1998 Ford Taurus

1 Answer

No heat on passenger side and warm air on drivers side


heater radiator blocked or partially blocked,drain antifreeze and save ,remove the inlet and outlet pipes for teh heater and flush in both directions repeatedly .brown rust should come out,if not a lot comes out then fit two pieces of pipe about a foot long to heater unit pipes and mix some caustic soda and pour in one pipe with a funnel till it comes up in other pipe leave for a while then flush again and you might need to repeat this two or three times

Dec 16, 2008 | 1998 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...