Question about Ford Laser

2 Answers

The room fuse keeps blowing when a new one is inserted.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is a short circuit thats why your fuse blow .trace the wiring if there is open or damaged that is touching the body of the car. put electrical tape on it.

Posted on May 18, 2011

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 111 Answers

There are wires touching some where

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No sound on radio but it shows channels. 20amp fuse blown and new on blows when inserted


I assume you already replaced the 100amp fuse. I would say thanks a lot to the person who helped you jump your car and, don't let them touch it again. If the 20amp keeps blowing, you have a short to ground on that circuit, possibly the radio itself. Good luck.

Oct 07, 2015 | Cars & Trucks

1 Answer

Efi fuse keeps blowing. After I insert a new fuse the engine starts and I'm able to drive until it blows again seconds later


there is a short in a unit or wire that the EFI unit runs. It may even be in the EFI unit itself. Insert a new fuse and run the fault codes to determine if a fault has been recorded.

Aug 09, 2014 | Cars & Trucks

1 Answer

Front windows fuse keeps blowing on my peugeot 307cc as i try to change it ,when I try to insert the new fuse it make sparks at the connector and the fuse blows I even tried to disconnect the battery first...


The fuse is blowing because there is a short to ground on the load side (between fuse and device being protected). Remove the inside door panel and take a close look at the wires between the window motor and where it feeds into the door. My bet is the up and down of the window gears scraped the wire bare. find the bare spot, electrical tape around exposed wire, secure the loose wire to the door using tie wrap so that metal does not contact wire. If there are not visible bare spots, remove the connection to the motor. You will need to pick up a short circuit tester, or a volt meter to isolate this problem

Oct 22, 2013 | Peugeot Cars & Trucks

1 Answer

Why does my room fuse keep blowing


Now you have a big Short, will be a good ide to Run the scanner/computer and fix it. Do not waste time+money. Remember the electronic vehicle is complicated now.
see the diagram attached.fb2b20d0-ca04-4fbe-a0f3-cba7c3144854.jpg

Jul 27, 2013 | 2000 Mazda 626

2 Answers

1990 new yorker. fuse for the dash lights,radio and dome ligjts keeps blowing


there might be corrosion on the ends of the fuse holder check that or try tuner cleaner before inserting the fuse.could also be a short in the fuse holder.

Sep 05, 2012 | 1990 Chrysler New Yorker

1 Answer

Sienna radio fuse keeps blowing


You may need to unplug the radio to see if the short is internal, and if not its probably in the harness.

Jul 11, 2012 | Toyota Sienna Cars & Trucks

1 Answer

No brake lights keeps blowing fuse. replaced brake switch was good for a week repaced switch again now keeps blowing fuses' I know theres a short but were...any Ideas


the notorious vw brake light switch!!! what color is your switch, black? purple? green? and are you installing it correctly? you should have the green one for i think it is the latest and greatest revised switch. super easy to do... T20 torx bit to remove panel remove plug from brake switch, turn CCW to remove, take new switch, and W/O pushing the pedal(IMPORTANT!!!) insert new switch and give it a click CW to seat it in place! reinstall connector and panel. let me know if that helps!

May 12, 2011 | Volkswagen GTI Cars & Trucks

1 Answer

Keeps blowing fuel pump fuse. Why?


This normally happens due to short in the wirings.Or if someone has connected a stereo or some other electrical contrivance to the wiring harness (bundle), either under the dash or under the hood.To confirm this unplug the fuel pump wiring connections and insert new fuse.Then start the car and see,if still the fuse blows then its a short in wiring.But if the fuse does not blows then its faulty fuel pump relay or faulty fuel pump itself.So first replace the fuel pump relay and see,if the fuel still blows then its faulty fuel pump.But if the fuse not blowing then relay was the faulty part.The fuel pump relay located on the fuse box under the hood.---------This troubleshooting tips will help you locate the fault and solve it.-------Thanks.Helpmech.

Dec 13, 2010 | 1996 Dodge Neon

1 Answer

1999 Jeep Cherokee Sport The fuse that handles power for the instrument panel, radio, remote key, interior lights, ... blows from time to time. When I insert a new one the new one immediately blows as...


Not sure but I advised you before!!
Any way last time!
You have to t/s the moment the fuse blows and elimate the systems (short) connected to that fuse, for sample, dis connect the interior light, install fuse, if it blows than it is NOT the interior light, keep going till you find the short!

Aug 22, 2009 | 1999 Jeep Cherokee

1 Answer

Fuse Keeps Blowing


Replace the lighter assembly, it is shorted, this is very common.

Nov 26, 2008 | 1991 Lexus LS 400

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...