Question about Chrysler Neon

1 Answer

I have a 2000 chrysler neon i put a flow threw exaust on it. this problem was going on before, to there is a hesatation on take off and chugging when driveing i replaced the coil pack and plugs and wires don't know what this can be

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 273 Answers

4 cylinder cars need back pressure (cat converter, muffler, and resonator) to get your full power to your car. Do you have any of these things on this car? If not, the best thing to do would be to put at least your CAT or resonator back on. Or, you should check out your O2 sensors. They may be getting too much flow. Hope this helps, James Booth. Please rate this. :)

Posted on May 18, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chugging sound at first but then sounds fine


Did you check two things 1) wheel bearings 2) break pads?

Jan 10, 2013 | 2000 Chrysler Cirrus

1 Answer

My chrysler neon 2.0 16 v is reving up sometimes and in second and third gears it starts to chug for a couple of secconds before driving right what would cause this?. year 2000..


Could be one of these things:
Dodgy exhaust sensor. Dodgy Timing Belt. Kanckered EMS (expensive!!!)

At worst you could have a dodgy solanoid in the auto box (this is what happened to mine) and that'll eventually put the car into "limp" mode - meaning no reverse gear and gears 1-3 only with max speed of around 54 mph (usually accompanied by flashing engine management warning light in amber). This set me back almost a grand to strip out the auto box and refurb it. The car has never been the same since either - it's ok but slower to change gear than ever before.
If the gearbox has a fault I would recommend ditching the car - it isn't worth fixing as the cost is roughly equal to the value of the car if it has a low mileage. If the mileage is above 100,000 you'd be lucky to get 1000 quid for the motor in the first place.
Sorry.

Aug 12, 2010 | Chrysler Neon Cars & Trucks

1 Answer

Start car with no airbag


Hello
My son races a neon on dirt fast car!=srt mopar stage 3 turbo kit,,, 3" exaust etc,,,
I would just remove tha airbages from the car there flamable if for some reason you have a fire they will go off even not conected.
drivers just unbolts from the wheel 4 10 mm bolts
pasanger bag have to go threw the glove box again 4 10 mm bolts
let me know if i can help more

Jul 15, 2010 | 1997 Dodge Neon

1 Answer

I have a 2000 neon, it shakes n netural, worse in


mass air flow sencer and idle sencer

Mar 04, 2010 | 2000 Dodge Neon

1 Answer

My truck hesitates and chugs than will clare up


There are several ways about this. Could be fuel filter, water in fuel, ignition part starting to fail(plug, wire, cap, rotor, coil) or possibly even oxygen sensor. The oxygen sensor will clear up if you accelerate heavily then when under normal load it will start chugging again. These are a couple of areas to check without getting into serious diagnostics.

Oct 12, 2009 | 1987 Ford Bronco II

2 Answers

How do you input the code in our radio of our chrysler neon


see here  for the Neon 2001 - 2008 

http://www.torbaycarstereo.co.uk/chrysler_p05091610ab.html

or if not try here

http://www.radio-code.co.uk/code-entry-help-Chrysler.htm



Sep 19, 2009 | 2000 Chrysler Grand Voyager

1 Answer

Head bolt torque specs for 2000 dodge neon 2.0 SOHC


I have the specs and diagrams. If you want me to send them to you, give me your email address. Outdoorsman592003@yahoo.com

Sep 01, 2009 | 1998 Dodge Neon

1 Answer

My 2000 dodge neon wants to fire over but it does


check the fuel line to see if there's a flow in the line, it could be tht you need a fuel pump or your not geting a fuel flow

Jul 11, 2009 | 2000 Dodge Neon

1 Answer

Power loss / low idle speed


This could be a multitude of things but my first suggestion would be to change the spark plugs. They are cheap and can be bought at any auto parts store.

Dec 16, 2008 | 2000 Plymouth Neon

1 Answer

Chrysler neon 2000 auto 1999


you need to get the code if you go to a auto parts store they can read it and tell you what part you need

Oct 22, 2008 | 2006 Chrysler Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...