Question about 1996 Jeep Grand Cherokee

1 Answer

Where is idle screws located on 1996 jeep cherokee

Posted by on

  • Richard Scordino May 18, 2011

    There are no idle screws. Idle is controlled by the computer via the idle air control valve. All other sensors and vacuum hoses need to be working and in good condition. IA valve is attached to the throttle body.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

Do Not adjust the idle, the idle is not adjustable. If there is an idling issue, it is related to another issue.

Posted on May 19, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Jeep cold start heater location


It likely has EFI (electronic fuel injection) and an idle air control valve that regulate idle speed. They can get gummed and fail to have a fast idle when cold, or get stuck the other way, and have a too fast idle all the or regularly take its time slowing down after you take your foot off the gas. An engine temp sensor can also cause a lingering high idle if it reports the engine as still being cold after warm up.

Aug 15, 2014 | 1996 Jeep Grand Cherokee

1 Answer

The engine in my 1994 jeep grand cherokee 4.0 idles very low (below 400 r.p.m's) when it sits still, Can I idle it up....how??


The idle speed adjustment on most fuel injected vehicles is located in a recessed hole near the throttle butterfly on the intake manifold(sometimes with a plug in it). Screwing out the adjusting screw should increase idle speed.

Aug 18, 2010 | 1994 Jeep Grand Cherokee

2 Answers

How to replace spark plugs on 2000 jeep cherokee classic 6 cyl.? Also does 2000 cherokee have inline fuel filter?


TO REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU HAVE 6 INDIVIDUAL COIL PACK TO EACH CYLINDER. YOU NEED A 3/8 RATCHET WRENCH - LONG 3/8 EXTENSION -SPARK PLUG SOCKET - SPARK PLUG GAUGE.AND TORQUE WRENCH.THE 2000 MODEL JEEPS FUEL FILTER INSIDE THE TANK.1993 - 1996 MODEL JEEPS FUEL FILTER LOCATED LEFT SIDE OF THE VECHICLE NEAR THE FUEL TANK.

Jul 20, 2010 | 2000 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee starts but wont idle


CHECK FUEL REGULATOR ON FUEL INJECTOR RAIL,&ALSO FUEL PUMP, CHARLIE

Feb 21, 2010 | 1996 Jeep Grand Cherokee

2 Answers

IAC Valve Location - 1996 Jeep Grand Cherokee


The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body. 
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order. 
 To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.

May 28, 2009 | 1986 Jeep Grand eer

1 Answer

Idle to high 1500 rpm


adjust idling screw on the carburator

May 01, 2009 | 1996 Jeep Grand Cherokee

1 Answer

LOCATION OF LIGHTER FUSE FOR 1996 JEEP GRAND


If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?

Apr 01, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Rattle/Shake during normal use, Rough Idle


1996 ,wow its classic its over 10yrs of age ,,,,,,renew it sounds like engine is finished

Feb 11, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Idle problem


its not real bad. it is located on the back side of the throttle body and is held in by 2 torx head screws. they are t 25 screws. remove them and slide the ais motor out and install the new one. when you start the vehicle up it may idle high for a while til the computer actually gains control

Jan 24, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...