Question about 1985 Pontiac Fiero

2 Answers

I have a 1985 Pontiac Fiero that keeps cutting off. We have replaced the alternator and the battery. What else could it be?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Could be crank or cam shaft position sensors fuel pump fuel filter injectors

Posted on Mar 09, 2012

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Ignition coil when dies. check for spark if there is no spark replace it

Posted on May 18, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 1985 fiero se v6 that was running fine but cutting off after warm up


Do you know what you are loosing when the engine stops running ?

Jan 16, 2014 | 1985 Pontiac Fiero

3 Answers

I need firing order and cylendor locations for replacing rotor and wires


1985 Pontiac Fiero 2.5 liter L4

zjlimited_222.gif



1985 Pontiac Fiero 2.8 liter V-6

zjlimited_223.gif



Hope this helps (remember to rate this answer).

Mar 03, 2011 | 1985 Pontiac Fiero

1 Answer

How do you replace alternator on 1986 fiero gt


Remove negative battery cable. Jack up rear of car. Remove passenger side rear wheel. Loosen A/C compressor tension bolt. Remove A/C belt. Disconnect 2 wire plug and single wire bolted to back of alternator. Loosen alternator tension bolt. Remove alternator pivot bolt from up top of bracket. Wiggle out through bottom.

Reverse for install.

Good luck,

Rebel Faggioli

Oct 07, 2010 | 1986 Pontiac Fiero

1 Answer

85 Pontiac Fiero - passing a smog testing


Could be vacuum or O2 sensor maybe using cheap fuel.

Aug 03, 2009 | 1985 Pontiac Fiero

1 Answer

Cant Find Headlight motor relay switch.


http://www.fieros.de/en/articles/headlight.html

Try there - Good luck

Jun 01, 2009 | 1985 Pontiac Fiero

2 Answers

Water pump housing


Hi, this water pump is a stand alone unit that is connected to the block by screws. it is not part of the block.

It has a few screws and you will have to remove the drive belt as well. Once you have removed the belt and the screws, it will slide of the bolts.

Please rate and god bless:)

Apr 28, 2009 | 1985 Pontiac Fiero

1 Answer

Need to locate the ignition control module in my 1985 fiero gt


Take off the distributor cap, it is held on by two screws and has three plugs, 1 to the pick up coil, one to the computer, and one to the ignition coil.

Mar 19, 2009 | 1985 Pontiac Fiero

1 Answer

Tail lights fora 1986 Fiero


rear of the car is totally different, if you want to do the gt conversion you will need to exchange the whole rear clip.
gt light are wider,cant use just the lens or cover.check for parts at vegas fiero club

Jan 27, 2009 | 1986 Pontiac Fiero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

284 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...