Question about 2002 Chrysler Sebring

1 Answer

How do i get the Intake maifold off so i can get to the spark plugs inderneath

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,140 Answers

You don't. plugs can be removed from under vehicle

Posted on May 18, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

F150 2013 V8 maifold intake torque specs

There is more than 1 v8, I need liter size of engine?

Aug 07, 2017 | Cars & Trucks

1 Answer

Engine turns but will not start

Is the fuel pump bad and is it getting spark, the easiest way to check theses is: Listen for the fuel pump and if you hear it, unhook the pressure line from the fuel rail. To check spark take out one spark plug and plug it into the wire, be careful not to ground it out on yourself though, and ground it to the intake maifold while someone turns the key, and look for spark.
One last thing is the timing could be wayyyyy off.

Jul 19, 2012 | Seat Cordoba Cars & Trucks

1 Answer

Intake noise

has it always done it? do you have an aftermarket cold air intake on it? if it has always done it...i think u r talking bout the vacuum relief of the intake manifold. no big deal

Mar 24, 2012 | 1997 Pontiac Grand Prix

1 Answer

Where is the coil located

This car has a coil pack. All six spark plug wires connect into it. It is located behind the air intake maifold. To get to it: (what I did)
1 Disconnect wires and hoses around the air intake area. Start at the air filter and go along to the air manifold. Loosen clamps at filter.
2. Loosen the clamp and remove the air intake hose. It justs comes loose. I left it in.
3. Disconnect the air valve (has butterfly valve). I forget the proper term. Just move aside.
4. Finish disconnecting hoses, i.e. pvc, EGR vacuum.
5. Remove the two nuts that hold the EGR valve to the pipe. Leave EGR attached to air manifold.
6. Remove the eight bolts that hold the air manifold.
7. Final check for anything still attached. Remove if needed.
8. Remove air manifold. You are exposing the air ways into your engine. Cover or stuff w/ paper towels to prevent getting contamination.
9. Now you have access to the coil pack. Three bolts.

If you have not replaced the plugs or wires, NOW is the GOLDEN time. WHILE YOUR in there.
Whether new wires or old, watch the transfer to keep in proper sequence.
Reverse order to put back. Use a bolt tightening pattern that pulls the manifold down evenly.
You may need a new gasket on the EGR connection.
Good Luck.

Dec 13, 2010 | 2001 Mercury Sable

1 Answer

Where is the PCV on a 2004 2.4 liter engine?

You can find it by following the pipe from the intake maifold or surge tank back to the tappit cover, PCV stands for positive crank ventilation. The fumes from the engine are sucked into the intake for burning on all vehicles with emision control.

Oct 02, 2010 | 2004 Chrysler PT Cruiser

1 Answer

Changing plugs and wires on an 01 mitsubishi eclipse do you have to remove the top maifold?? if so is if hard if you never done it

Assuming you have a V6 yea the upper intake has to be raised up. The book time is 2 hours. I guess I would say the job is semi easy.

Jun 21, 2010 | 2001 Mitsubishi Eclipse

1 Answer

Replace intake maifold gasket on 1999 venture van

Hi,I just replaced mine.It is not that hard.just buy a manual on it at autozone,and it gives the specifications and step by step directions to dissassemble,and reassemble.I put in new plugs,thermostat,and flushed the motor for around $200.00.runs great!

May 09, 2010 | 1999 Chevrolet Venture

2 Answers

Dtc p0302,p0171,p0174. van sputters like it wants to die.runs ok once you get going but wants to stall. what do i do?

Code P0302 is misfire cylinder Number 2
Could be spark plug, wire or coil

P0171 & P0174 Running Lean
Vaccum leak Possible intake leak or PCV system leak.

Sep 22, 2009 | 1999 Ford Windstar

1 Answer

Manifold gaskets

If you are talking about 3.4L engine there are only two manifold gaskets. But there are Four Intake gaskets two for the upper intake and two for the lower intake.

Oct 08, 2008 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides