Question about 1995 Chevrolet Caprice Classic

1 Answer

When the car is in park it is idle and remains on but when put in gear it turns off

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Tourqe converter no doubt

Posted on May 17, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

85 ford f150 302 v8 2val carb stall when put in gear


How long since a tune-up? Have you checked the timing? How many miles on engine? How is your cylinder compression?
There isn't much load on engine in park or neutral. When you put it in gear, there is a load on the engine. With carbed engine 6--8 psi fuel pressure. Crub idle in drive, 575 rpms. With a high mileage engine, that idle speed may not work. Is there an idle screw on the carb, where you can up the idle to keep it from stalling, in gear? Of course if you do that, when you put it in park or neutral the idle is going to go high, I know it's a pain. If your engine is in poor shape, your probably going to have a tough time, getting it to run correctly. Just my opinion.

May 17, 2018 | Ford Cars & Trucks

2 Answers

Is their a linkage ajustment on the 03 Deville transmission


No adjustment however check your linkage /shift cable. Somethings off track

Jan 11, 2015 | 2003 Cadillac Deville

1 Answer

Engine revs but no acceleration


Clutch plate and pressure plate seem to be too weak to pull the car. Or one of the CV joints is detached from the gear box. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

My Sable will turn on fine but when i try shifting the gear they won't go in the shifter just glides along and the car remains idle. The day it started doing this it made a loud screeching noise and...


If the shifter moves but does not feel like it is trying to put car in gear the cable that goes from the shifter to the transmition could have broke or came loose. If that happened while driving the gears may have tried to shift when tension was released from the cable.

May 10, 2011 | 1999 Mercury Sable

1 Answer

The idle drops when i put it in gear almost stalling the engine


That is normal, in park or neutral there is no resistance on the engine when you put it in gear there is resistance because the car wants to move. Also when you turn on the ac that turns on the compressor that is run off the belts of the engine so it puts more resistance on the engine. Low idle is not a problem unless the engine dies.

Oct 22, 2009 | 1992 Honda Accord

1 Answer

Truck idles in park but drops to about 500rpms and lower if idling in drive and dies.


sounds like the idle air control vavle. when you put a load on the engine such as putting it in gear or using the ac or turning sharply, the iac is suppose to let more air in so the engine will idle up a little. if its stuck and you load the engine by pulling it in gear it will let the idle drop and possibly die.

Oct 03, 2009 | 2004 Ford F150

1 Answer

Audi a3 1998 automatic transmission cannot shift into gear


have you checked the brake lights for operation ?
if they don't work than it is your brake light switch located on the pedal support bracket.

May 14, 2009 | 2005 Audi A3

Not finding what you are looking for?
1995 Chevrolet Caprice Classic Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...