Question about 2003 Nissan 350Z

Open Question

I have a 2007 maxima and just recently my tcs/slip light came on and my car stalled out. What is the problem?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 321 Answers

SOURCE: TCS/SLIP & Check Engine Light Warning

TCS is Traction Control System,and all TCS's are controlled though the Anti Lock Braking (ABS) system.Here's how it works:Each wheel,or in some cases,only the drive wheels have a speed sensor mounted near the hub or axle,and sends a speed signal to the PCM (Powertrain Control Module).The PCM monitors wheel speed continuously,and if it sees a speed out of the ordinary,say for example the right rear tire is spinning and traveling at a much higher speed than the left rear,the PCM will pulse the brakes through the ABS system on the right rear to slow down the right rear so that the left and right wheel speeds match up,this is how the traction control works.So,if you have a TCS problem,the PCM will see this and set a Dignostic Trouble Code (DTC).You need to pull the DTC's out of the system with a scan tool,diagnose and repair the DTC's.It could likely be something as simple as a malfunctioning wheel speed sensor,but you won't know until the codes are pulled out,as this will point in the general direction.Good luck.

Posted on Aug 09, 2008

Ad
  • 10 Answers

SOURCE: I put a washable air

Removed the positve and negative charge of battery for 10 minutes then, plug it back the positive first then negative charge and the last step you do is to start the engine. This steps is to clear tcs off, slip and awd lights.

Posted on Jan 24, 2009

pal03246
  • 726 Answers

SOURCE: TCS, SLIP and ABS lights on

Check your brake fluid first. If that is low, top it off and recheck. If its ok, than you will need one of the rear ABS sensors. You will need to plug it in and find out which side it is. That's really the only ABS issue that car has. One of the rear ABS sensors fails.

Posted on May 09, 2009

  • 43 Answers

SOURCE: 350z speedometer stuck at 0 with VDC.TCS/ABS/Slip lights on

check the cable which leads from the tranny to the dash, most of the time the cable or sensor went bad

Posted on Sep 23, 2009

  • 194 Answers

SOURCE: p1320 trouble code plus

The P1320 code is essentially a coil primary voltage problem. This is traceable using a labscope or accurate DVOM and perhaps you can isolate one or two coils that still work but are close to failure...but there is a nissan service message recommending replacement of ALL coils with updated/improved models to prevent this type of failure. TCS/SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel.

Posted on Sep 09, 2009

Testimonial: "thanks needed a point in the right direction"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix a 2000 nissian maxima with warning lights tcs off and slip?


try pushing the botton tcs and it may go off unless something else is broken

Jul 16, 2014 | 2000 Nissan Maxima

1 Answer

The ABS, TCS OFF,and SLIP warning lights are on in my 2000 Nissan Maxima. What's the cause and fix?


cud be dirty or low brake fluid----or bad abs module--or more------have system inspected by a brakepro soon before it cost alot or u crash

May 09, 2012 | 2000 Nissan Maxima

1 Answer

The tcs light came on and now the car do not start and the slip sign came too..


engine swap on nissan maxima 2005 code 1212 came up,check wiring all good,the car starts then stall any suggestions,abs fuse is good

Feb 19, 2011 | 2005 Nissan Maxima

1 Answer

My 2002 maxima has the abs, slip., and tcs lights on and they stay on


could be a bad abs sensor on one of the wheels, or it just might be covered with alot of dirt, unable to get a good reading. Also if you replaced anything suspension, breaks, or axle related recently, someone might have messed up the wiring

Nov 22, 2009 | 2000 Nissan Maxima

2 Answers

P1320 trouble code plus


The P1320 code is essentially a coil primary voltage problem. This is traceable using a labscope or accurate DVOM and perhaps you can isolate one or two coils that still work but are close to failure...but there is a nissan service message recommending replacement of ALL coils with updated/improved models to prevent this type of failure. TCS/SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel.

Sep 09, 2009 | 2000 Nissan Maxima

2 Answers

I am planning to buy a nissan maxima.but the seller said the ABS.TCS and slip lights are on which is making the tranny to slip a bit. is this true. 1. why would the tranny slip? 2. why also are those...


can be an expensive problem the abs and tcs module under the hood is probably going bad the tranny slipping is probably what is causing the othe lights to come on. the tcs stands for traction control system if it feels a slip in the tranny like on a gravel road or wet road it assists the vehicle into getting better traction.

Aug 27, 2009 | 2004 Nissan Maxima

1 Answer

Hello, I bought my Maxima SE 2 weeks ago, the light of "service engine soon" turns on and some times the TCS and SLIP lights are turning on and off and whenever these lights come and go, the...


As for trouble codes, and the dealers recommendation. They are true and accurate, although I would get a second opinion from another auto shop other than the dealer. Do not disclose what you already know other than the problems you are expriencing.

Apr 27, 2009 | 2002 Nissan Maxima

1 Answer

2002 maxima TCS slips or disingages for no apparant reason.


2000 & 2002 Maxima TCS slips or disingages and idle becomes rough for noreason.

Mar 26, 2009 | 2002 Nissan Maxima

Not finding what you are looking for?
2003 Nissan 350Z Logo

Related Topics:

1,841 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...