Question about Ford Explorer

2 Answers

LOST THE ONLY KEY TO MY 2000 FORD EXPLORER. HOW CAN I GET A NEW ONE?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,970 Answers

Did you try the dealer? Or visit this reference link: 2000_Ford_Explorer

About the programing procedure, read this info... Programming a PATS II Key

Ordered a PATS II key ( Passive Anti Theft System ) from Torrie McPhail at Ford Parts Network ( http://www.fordpartsnetwork.com/ ). The key, cut for the truck ( using the VIN ), shipped to door was only $24.85. Ford Parts Network is a great company to do business with; highly recommended.

I am able to program the new key ( PATS II ) myself ( on my 99 ) since I have two good ( programmed ) keys, if I had only one key, it would have been necessary to have a Ford dealer or specialty locksmith make the key ( unless the truck was a pre 98 with a PATS I system; then only one good key is needed ). I have been told that the cost of this programming and a key is around $100.

The programming procedure is as follows: insert the first good key turn it to the run position wait until the security light goes out, turn to lock and remove the key'; now insert the second good key and repeat the step; finally insert the new key and repeat. The security light will light up for three seconds to indicate that the new key has been successfully programmed.

That's all there is to programming the new key; total time less than one minute.

Moral of this story - even if you have two good keys, order another ( or 2 ) and program them yourself and avoid future headaches and expense.

Hope helps.

Posted on May 27, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 87 Answers

Go to dealer and bring your proof of id and paper work for vehicle. There maybe an additional programing fee, this is normal protocol. Or try a local locksmith but make sure you tell them over the phone your vehicle info.

Posted on May 17, 2011

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: I lost my key for my 99 ford Explorer Sport 2

Cheaper if you call a Locksmith.Call Around..........................

Posted on Jun 30, 2009

  • 869 Answers

SOURCE: 1998 Ford Explorer: My mother lost both keys. I

the keys and locks are not only specific to a particular ford explorer year model but they are also specific to a particular model.

Posted on May 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford explorer fuse panel, what fuses and amps are used for each fuse


Try 2000 ford explorer fuse panel what fuses and amps are used for each fuse

Dec 18, 2016 | 2000 Ford Explorer

1 Answer

I lost my key to my 2000 Ford Explorer how can I bypass the security and crank my vehicle


call a wrecker and tow the vehicle to your ford dealer and have the key programmed to the vehicle.

Apr 28, 2015 | 2000 Ford Explorer

1 Answer

Im working on my ford explorer


car theives use a slidehammer to remove the key..in your case if you dont want any damage.. call a locksmith..

Dec 22, 2013 | 2000 Ford Explorer

1 Answer

2000 ford explorer starts but dies instantly. explorer sat still for 6 years. does key for 2000 explorer have a chip in the key?


Yes it does. Does it sound like it is trying to turn over? I had the same proble.First time was a bad ground second time was fuse.

Oct 25, 2010 | 2000 Ford Explorer

1 Answer

How can i program my door lock code or find out what it is. on my 2000 limited edition explorer


FORD KEY PADS
  • Enter permanent factory code
  • Press the 1/2 button within 5 seconds to enter programming mode
  • Within 5 seconds enter new code, doors will lock, unlock to verify code, this erases previous codes remotes will also need to be programmed.
FORD KEY PADS/REMOTES
  • Insert key, turn ignition off-to- on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode
  • Press any button on new remote, doors will lock, unlock to verify
  • Do the previous step with the second remote, doors will lock unlock to verify.
  • Turn ignition off. Doors will again lock, unlock to verify.
NOTE-I found that some Explorer/Mountaineers enter program mode after 5 times-not 8.

Here is the link for further info.


http://www.2carpros.com/how_to/how_to_reprogram_key_remote_fob.htm


Your factory code is on a card in the owners manual. If that is lost, access the control module in the cargo area behind the left cover panel.

You MIGHT be able to see the code printed on it, or you might need to pull it out in order to see it.

May 27, 2010 | 2002 Ford Explorer

1 Answer

Need a New chip key!


try this website to see if they have your car listed its www.edmunds.com for a online owner manual if it not showing you how in the manual you then would have to take the car to a ford dealership to have both remotes reprogramed iam sorry i do not have a manual Michigan Man

May 08, 2009 | 2001 Ford Explorer Sport

1 Answer

On the 2000 explorer patts key .can i change that part that has 1 screw under it.


Fords have a pats system that sends a signal to the computer without the correct key the truck will not start.

Jan 08, 2009 | 2000 Ford Explorer

2 Answers

I lost the chipkey to my2000 explorer.tried to get one programed


No you will need the key with the chip in it or the truck will not run. The key has a transmitter in it and when you put it in the ignition it sends a freqwency out and that is how the truck starts or dosent get stolen if ya dont got the key.

Jan 08, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...