Question about Volvo S80

Open Question

Engine systems service required 097 fault code what is this it comes on my vlovo s 80 d5 2007 when i start the car

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

martin538
  • 117 Answers

SOURCE: i have engine service required message and fault code 042

P0042 : Heated oxygen sensor (HO2S)bank1, heater control -circuit malfunction.

The code is telling you one of the oxygen sensors or the wiring to it is faulty.

Posted on Apr 09, 2009

sodeep
  • 3267 Answers

SOURCE: V70 D5 2007 MANUAL.Excesive vibration coming

Get the engine tuned at any service station which uses a PC for diagnosing & rectifying the tuning very accurately. But before you do that, rev up the engine and observe whether the engine starts vibrations. If so, check engine mounting bushes and replace if deformed. However when a vehicle starts vibrating at high speed, its due to with the main axle which ends up at the differential. Both ends of this main axle have spider bearings at both ends. All bearings will have to wear down with use. A play will compound the effect at higher rpm.
As far as the engine is concerned, i.e. roughness of engine can be eliminated by using carb. cleaner for the injector nozzle which accumulate carbon at the nozzle tips, such that all cylinders are not able to provide equal force during combustion....sodeep

Posted on Oct 02, 2009

  • 630 Answers

SOURCE: 2002 Volvo V70 D5 engine service required showing

The service indicator works on how you drive the car rather than on mileage

Posted on May 01, 2010

  • 1 Answer

SOURCE: Make is a volvo s60 D5, with a fault code 075 it

Volvo s80, 2004 ,.2.4 petrol. I have codes 042,058,075.This big problem? Thanks Ana

Posted on May 28, 2010

  • 1 Answer

SOURCE: i have xc90 d5 there

Hi,

This is probably due to a problem with the swirl flap actuator arm - if you remove the top of the engine cover (the plastic bit) and look at the top, left front of the engine, do you see a plastic arm (approx 70 - 100 mm long) disconnected?

Regards,


RK

Posted on Feb 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Abs light is on


When the ABS warning (or any other for that matter) comes on a fault code is set in the computer control module, to start diagnosis and testing you need to have that fault code, that requires the ABS system be scanned for fault codes. Right now the ABS system has been disabled until the problem is repaired.

Dec 20, 2016 | Jeep Cars & Trucks

1 Answer

My abs light don't come on my ford 2003


abs light on dash panel should only light for two seconds upon starting of engine , then go out . if it comes on and stays on then this indicates a fault has been detected in your abs system , by body control module (fault can be any where on car) a code reader will be required to know reason for abs fault

Jun 24, 2015 | Ford Cars & Trucks

1 Answer

Engine system service required error code 097. What does this indicate?


go to autozone or advance auto or Oriellys and get it scanned code and possible causes then you will know more

Apr 02, 2015 | Volvo Cars & Trucks

1 Answer

Service soon light on,cuts off when at idle,hard to start back.


The information below was complied by me, it explains what causes the check engine light or Service Engine Soon light to come on and the process of finding the cause.

When the Check Engine light or Service Engine Soon light (depends on make) is turned on the computer control unit (called the PCM) has sensed a fault in the electronic controls of the engine and/or the emission system. When this happens you will seldom feel the car engine run any different. There are about 200 possible faults that turn the Check Engine light on, to know what has developed a problem you must have the system tested, this is called an OBD2 fault code test, Kragen and Autozone parts stores do this testing for free.


Mar 17, 2011 | 2000 Nissan Altima

1 Answer

My 2007 Dodge cummins 6.7 is telling me to perform service and the catalyst is full. How do I fix this problem myself?


Intervention Regeneration Strategy - EVIC
Message Process Flow (Catalyst Full Message)
(6.7L Diesel Engines Only)

Your new Cummins 6.7L diesel meets all EPA Heavy
Duty Diesel Engine Emissions Standards, resulting in the
lowest emitting diesel engine ever produced.
To achieve these emission standards your vehicle is
equipped with state of the art engine and exhaust system.
The engine and exhaust aftertreatment system work
together to achieve the EPA Heavy Duty Diesel Engine
Emissions Standards. These systems are seamlessly integrated
into your vehicle and managed by the Cummins
6.7L engine Powertrain Control Module (PCM). The PCM
manages engine combustion to allow the exhaust system's
catalyst to trap and burn Particulate Matter (PM)
pollutants, with no input or interaction on your part.
Additionally, the overhead console in your vehicle has
the ability to alert you to additional maintenance required
on your truck or engine. Refer to the following
messages that may be displayed on your Electronic
Vehicle Information Center (EVIC):

WARNING!
A hot exhaust system can start a fire if you park over
materials that can burn. Such materials might be
grass or leaves coming into contact with your exhaust
system. Do not park or operate your vehicle in areas
where your exhaust system can contact anything that
can burn.

Perform Service
The 6.7L Cummins engine utilizes a Closed Crankcase
Ventilation (CCV) system, EGR Valve and a EGR Cooler.
This system filters and recycles gasses produced in the
crankcase during the normal combustion process. Perform
Service will be displayed on the overhead console of
your vehicle if the CCV filter, EGR Valve and EGR Cooler
is due for required maintenance. The CCV filter is located
on the top of the engine valve cover. For additional
information, see your local authorized dealer.
Catalyst Full See Owner Manual
Catalyst Full See Owner Manual will be displayed on the
overhead console of your vehicle if the exhaust particulate
filter reaches 80% of its maximum storage capacity.
Under conditions of exclusive short duration and low
speed driving cycles, your Cummins engine and exhaust
aftertreatment system may never reach the conditions
required to remove the trapped PM, if this occurs Catalyst
Full See Owner Manual will be displayed on the
overhead console in your vehicle. If this message is
displayed you will hear one chime to assist in alerting
you of this condition.
Catalyst Stat::::::::::80%
Catalyst Stat::::::::::80% will replace the message Catalyst
Full See Owner Manual after it is displayed for one
minute. The engine Powertrain Control Module (PCM)
will continue to monitor the amount of particulate matter
trapped in the particulate filter. This message indicates
the percentage of the particulate filter capacity that has
been used.

By simply driving your vehicle at highway speeds for as
little as 45 minutes you can remedy the condition in the
particulate filter system and allow your Cummins engine
and exhaust Aftertreatment system to remove the
trapped PM and restore the system to normal operating
condition.
Catalyst Stat:::::::::::80%, 90%, 99%
Catalyst Stat:::::::::::80%, 90%, 99% If you are unable to
drive your vehicle under these conditions for an extended
period of time after the initial warning notification,
the Engine PCM will continue to monitor the
particulate filter and will display the progression of
particulate filter usage (80, 90, 99%) on the EVIC message
center.

CATALYST FULL SERVICE REQD
If the particulate filter reaches 99% of it's capacity the
overhead console in your vehicle will chime twice and
display the message CATALYST FULL SERVICE REQD.
At this point the engine PCM will register a fault code,
the instrument panel will display a MIL light and the
engine PCM will derate the truck reducing its horsepower
and torque output.
The PCM derates the engine in order to limit the likelihood
of permanent damage to the aftertreatment system.
If this condition is not corrected and a dealer service is
not performed, extensive exhaust aftertreatment damage
can occur. In order to correct this condition it will be
necessary to have the truck serviced by your local
authorized dealer.

Feb 14, 2011 | 2007 Dodge Ram Truck

1 Answer

Hi i have a 2004 bmw 320d just fitted a recon engine and wont start coming up with crank shaft sensor fault put a new one on and still wont start any suggestions please thanks


Hi Mountview,
First thing I'd suggest you do is delete the fault codes from your scanner....The engine management computer stores them, and they may be from your old engine?
Run another scan and if the codes come up again check the cables to the sensor. Defective parts are not unknown, especially where I am....
The anti theft device may have kicked in and be inhibiting starting....This will require resetting on your scanner.
Once you've checked all of that, bleed the diesel system, as if there's any air in the fuel line, it won't start
Regards Johngee10

Nov 19, 2010 | BMW 3 Series Cars & Trucks

2 Answers

CHECK ENGINE LIGHT


there are over 200 system faults that turn the check engine light on, have the systems computer tested, there should be a trouble code present to ID the fault(s)

Sep 28, 2009 | 2004 Saturn VUE

1 Answer

Check Engine/Transmission service required


have the code read at a partsource or if you have a reader check the trouble code. could be low on transmission oil or its the computer with the factory set parameters on when your next transmission service was due

Jul 19, 2009 | 2002 Volvo S80

2 Answers

I have engine service required message and fault code 042


P0042 : Heated oxygen sensor (HO2S)bank1, heater control -circuit malfunction.

The code is telling you one of the oxygen sensors or the wiring to it is faulty.

Apr 08, 2009 | 2005 Volvo XC90

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,086 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...