Question about 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

Brakes 350 ford supercab

Put new brake pads on , bled brakes and master cylinder but peddle still goes to floor

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 53 Answers

You have to make very sure that you got all the air out of the system. and make sure that you bled it in the right order. start at the furthest from the MC and work your way toward it. It will take a couple of times. Hopefully when you pushed the piston on the caliper back in you relieved the pressure through the bleed valve cuz if you didn't you can actually ruin the Master Cylinder by blowing out a relief valve by the backflow of the fluid.

Posted on Aug 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 ford taurus brake pedal goes straight to the floor .


Brake line busted somewhere? Is the linkage to the master cylinder intact? Master cylinder might have been installed incorrectly.

Dec 04, 2013 | Cars & Trucks

1 Answer

I HAVE A 95 F250 AND THE BRAKE PEDAL GOES TO THE FLOOR. I HAVE REPLACED THE MASTER CYLINDER TWICE AFTER BENCH BLEEDING, REPLACED THE BRAKE BOOSTER . BLED THE SYSTEM 3 TIMES AND THE BRAKE PEDAL STILL GOES...


You need to check wheel cylinders, the only way that the brake peddle will go to the floor like that is if there is a lose of fluid pressure somewhere .

Dec 29, 2010 | Ford F-250 Cars & Trucks

1 Answer

Rusted rear left brake line replaced, fluid drained from master cylinder. Left the line open while I picked up the new line. Bled all four brakes, but the peddle goes to the floor (slowly) with medium...


Did you remember to bleed the master cylinder itself? When the master cylinder runs dry you should start bleeding your brake system at the master cylinder and then continue on to each of the four wheel cylinders.

Dec 15, 2010 | 1997 Oldsmobile Aurora

2 Answers

When driving and applying the brakes pedal goes to the floor brakes do stop but no peddle . looking for a diagram of the fuse boxes and such


perhaps the master cylinder is sick put a little pressure on the pedal and keep your foot on the pedal just to keep it hard a little if the pedal goes down slowly the it s the master

Jun 19, 2010 | 1995 Ford Ranger Supercab

2 Answers

Brake pedal goes to floor,replaced front pads rear good,bleed brakes no help


Hi:
If you have replaced all pads, and see no leaks at any wheel, and have bled your brake system, then most likely your brake master cylinder has failed.

Dec 18, 2009 | 2001 Ford Taurus

3 Answers

Brakes are still spongy after changing the pads, one caliper, and master cylinder. bled front brakes.


I just went to Brake Masters this morning and had them replace the Master Cylinder since I was experiencing the pedal very spongy and going to the floor. When they replaced the Master Cylinder and they gave me back the car, the brakes were still spongy and going to the floor. I addressed this to them and they took another look at it, but when I took it for a second time, the brakes were extremely spongy. It was almost like they gave me back my car in worst condition to when I brought it in. Can you help?

May 21, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

1989 Ford F350 2 wheel drive dually 460 ci gas motor


5 Inspect Brake Fluid Type Brake fluid loss or contamination grey_line.gif 10 Inspect Master Cylinder (Brake System) Worn or leaking brake master cylinder. grey_line.gif 11 Inspect Brake Power Booster Damaged booster vacuum line/check valve, or diaphram

Nov 24, 2008 | 1989 Ford F 350

Not finding what you are looking for?
2003 Ford F350 Super Duty DRW SuperCab Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...