2006 chevy equinox makes a roaring noise when acelerating. what could it be?

The half shafts o.k.?

Bottom of motor

It could a wheel bearing. See if the noise gets louder at higher speeds. If it does trying jiggling the steering wheel (in a safe manner) from left to right and see if the noise gets higher or lower. If it does then you have a front wheel bearing that is bad. If not then if could be a rear wheel bearing. If none of these apply to you then try checking your transmission fluid level and fluid condition. It is posible you could have an internal transmission issues. The fluid should be bright red. If brown or black I would consider taking it to a transmission shop to it further looked into.

Rotors could be one problem.Check fluid level.Who did the brakes.Abs is sensor which is in hub bearings .Could be bad.

Take it to a qualified repair shop .

while the wheel bearings still feel tight they are the cause of your problem, after a collision most cars suffer from this problem depending on the speed of the accident the forces encountered during a sudden stop causes intense stress and fatigue on the bearings

I have a 2006 chevy equinox and when i started it it had a quiet tick which was a completely new development. As I drove it became very loud so we pulled over turned it off...started it again after a coupld minutes it started but noise was still there, checked the oil it read low so we added two quarts then it wouldn't start meanwhile no smoke showed no burning smell didn't overheat and now lights came on.

Front Left Hand LH Driver Side Door Check Stop Linkage
2005 2006 2007 2008 2009 Chevrolet Equinox
Genuine GM Part Number:15861661

wheel speed sensors, is the light staying on for ABS ?

i want to buy a 2006 nissan patherfinder tires make a roaring is this a problem