Question about 1999 Toyota 4Runner

1 Answer

How do yu get the starter out? - 1999 Toyota 4Runner

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

There are 2 long screws that holds the starter. Remove battery first before doing any work. Since the 4runner has a high clearance, I did not jack up the car but it would be easier if you have a ramp. Make sure you have the right tools to remove those 2 screws. Remove the positive and negative terminals first.

The replacement starter has to be the exact size as the old one. Don't buy from those auto parts chain for $180. Google around your area for car electrical shops that remanufactures those starters for only $45.

Took me 1.5 hours and only spent $45 for the starter.

Posted on Aug 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

REMOVING A STARTER FROM A 1999 DODGE CARAVAN 3.3 FLEX FUEL ENG


The starter can be accessed from under the vehicle.Its just fitted on blts.Its not very difficult to replace starter.But the bolts are removed by special tool.Yu can get the tool from local auo part stores.Its easily available. Car no start problem is sometimes very difficult to confirm. You try all the possible things, but still you get no fault and problem is still the same.--------
In that case, you need to check few things individually.
Check the spark,the battery,the crank, the fuel and other most possible parts. Click this link below for more details:-- http://howtobyme.blogspot.com/2011/10/car-troubleshooting-tips.html

Oct 02, 2011 | 1999 Dodge Caravan

1 Answer

Land Rover Discovery TDi 1 - I hooked up the battery with the polarity reversed then I reconnected it the right way but the engine will not start, not even the starter.


It is possible you burned an inline fuse, starter selonoid.

Do yu get power for the accessories? If so, check the power ging to the starter and work backwards to resolve. Hope you did not fry the Control Module, check all your fuses!

Oct 04, 2010 | 1997 Land Rover Discovery

1 Answer

I've been told my immobilizer is shot and need to find an engine ECU,immobilizer ECU and key all from same car or mine is a scrapper , can yu give me some info as i know next to nothing on cars , its a...


The immobilizer essentially is a relay they spliced in series between the ignition lock and starter solenoid. All you have to do is jumper these 2 wires back together again. You can test wich wire to the immobilizer is from the ignition by watching a test light probed to the contacts when someone cranks the engine. The solenid wire is easier to trace because you can follow it from the starter.

Apr 12, 2010 | Mazda MX-3 Cars & Trucks

1 Answer

How do yu install a geo tracker starter


disconnect ground
remove starter solenoid lead wire and battery cable from starter terminals
remove starter to engine retaining bolts, then the starter
reverse prosedure to install

Feb 09, 2010 | 1995 Geo Tracker

1 Answer

The car will not start. It has plenty of battery volts but it does not make a sound when you turn the key.


check battery voltage at solenoid on starter... yu say you have plenty of voltage, I assume you menat at least 12 volts... needs to be at least 12 volts... again tap on starter with key ign switch activated, have some one help... please rate help. thanks

Aug 05, 2009 | 1990 Nissan Sentra

1 Answer

How to replace a starter for the Issuz 1998


first you have to disconnect the battery, then disconnect the wiring in starter after that yu unscrew the mounting bolt turning counter clockwise. Remove the stater pulling it slowly, then fix the new one screw all nuts back. then reconnect all connection including battery . its done.

Jun 07, 2009 | 1998 Isuzu Trooper

2 Answers

2003 chevrolet blazers alarm sounds without cause,domelgt&lock is


do you have a remote starter on the truck? if you do try disconnecting it first to see if this solves the problem because it sounds like your security system is shorting out and the remote starter can sometimes cause this if not properly installed. also call Schram auto and truck parts they sell and specialize in only GM parts 1-800-292-1032

Mar 12, 2009 | 2003 Chevrolet Blazer

1 Answer

Chevy blazer tahoe v6 4.3 vortec won't even give me a light


any losen weire araund starter?on starter hawe 3gray fusebel link weire and hawe to conect with same weire from batt big red weire.if are conected chek gray 3 weire by sleigty poling on weire and see if is brocken samtime brick iseide under insolation and yu cant see disconect batt before inspection

Mar 12, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
1999 Toyota 4Runner Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...