Question about Mazda Tribute

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,586 Answers

You may have air in the system - bleed the clutch, top off the fluid, and see if that helps.

Posted on Aug 14, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1997 Toyota hi ace commuter has a spongy clutch is it a cable or hydrolic clutch and if a cable is it adjustable

spongy clutch feeling normally is Hydraulic.If you get under the vehicle -after you take all the safety precautions first- get close to the gearbox housing ( it is where the Engine joined the housing) and on the side of that housing you will see a flexible hose covering the clutch bearing fork and a clutch slave cylinder attached to that fork. Possible to see that is wet of clutch fluid (if is that the fault ). Also check if the clutch master cylinder is the fault and the clutch fluid reservoir if it has sufficient fluid in.

Dec 31, 2017 | Toyota Cars & Trucks

1 Answer

2005 V6 Mustang. When I make a hard stop, the tranny disengages for several seconds and then drops back in. Then when taking off again it's like the clutch is slipping. It's an automatic. The tack is also...

A couple days of driving like that, and you will
be pulling the trans, and emptying your bank account

I would not drive any of todays high tech vehicles,
farther, than to get home,then park them,until you
diagnose and repair.

You could possibly need a new trans pressure control
and solenoid pack , in trans,if it doesn't shift perfectly,
and if the tach flairs at all,it is slipping,good luck on that.

Don't use it at all, get it checked out

Dec 14, 2010 | 2005 Ford Mustang

1 Answer

2002 Kia Sportage Car spongy clutch pedal Answer The clutch pedal is very spongy, and sometime has not pressure on the pedal at all when the vehicle... (More) The clutch pedal is very spongy, and sometime...

The spoongy feeling is a defective clutch slave cylinder. Generally a cluthc will not slip because of a pressure issue with hydaulics.

If the clutch is slipping with your foot off the pedal it defineately is time for a clutch job... Best bet is to get it inspected to be sure.

Jan 04, 2010 | 2002 Kia Sportage

1 Answer

Spongy clutch pedal

Depends on mileage.
If it's due to be changed, replace all parts, but I'd guess a hydrulic issue or adjustment problem.

Jan 03, 2010 | 2002 Kia Sportage

1 Answer

2001 hyundai accent clutch feels spongy and the

seems to be a worn clutch... Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.

Sep 23, 2009 | 2001 Hyundai Accent

3 Answers

2003 f150 clutch was fine and now almost on floor before disengages. No fluid leak maybe air but where to bleed is a mystry

At the small cylinder on the clutch housing, also you can adjust the free play, about 2 to 3 mm.

Aug 11, 2009 | 2003 Ford F150 Regular Cab

2 Answers

Air conditioner takes longer to cool than it used to.

Could be low on gas.. Have it checked..
If it get too low it might shut down the compressor or even damage it..

Jul 09, 2009 | 2005 Ford Five Hundred

1 Answer

Elantra 2001, A/C compressor clutch engages and disengages every 2 sec.When i first start the engine I got cool air then, after the engine is hot, the problem starts and bye bye cool air!

The a/c clutch engages then disengages intermittently with the Hyundai's a/c system when there is little or no refrigerant in the system.

Have your a/c refrigerant (R134 or R12) checked and refilled, and have the system inspected for leaks.

Hope this helps.

Jun 25, 2009 | 2001 Hyundai Elantra

1 Answer

1990 300zx N/T Clutch not engaging properly

Your Friction disk (clutch) is worn out. Have it replaced....might also need pressure plate, but not necessarily.

Apr 13, 2009 | 1990 Nissan 300ZX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides