Question about 2006 Toyota MR2 Spyder

1 Answer

MR2 Turbo - After a good run the exhaust "pops" and bangs as if car is overfueling. How do I stop it doing that?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Re-adjust the fuel supply by turning the screw on the top of the throttle body

Posted on Oct 27, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 HYUNDAI Elantra develops heavy black smoke and low pulling power runs 147198kms. Please supply the causes


the cause of the heavy black smoke is un-burnt fuel. is from excessive fuel pressure, faulty injectors,ignition timing out. If it is a turbo operation then the turbo is not producing the correct boost for the fuel settings . Check turbo for vane actuation . low power comes from overfuelling, low air flow. run the fault codes to see which sensors are out of parameter.

Nov 18, 2014 | Hyundai Elantra Cars & Trucks

1 Answer

I am fitting new stem seals on my toyota mr2 turbo 1994 *** inport . the seals i have got are green and blue so what one goes on the exhaust stem .


What is the brand of gasket set do you have, it should be printed on the contents what seal goes where. Or call the tech line for the mfg of the gasket set.

May 12, 2010 | 1994 Toyota MR2

2 Answers

Hi, what does it mean when huge amounts of white smoke comes out of the exhaust? otherwise drives ok? it is a renault megane 1.5 dci 2004. regards catherine


Symptom: White smoke or water vapor from the exhaust. You notice white smoke coming from the exhaust when you start your car. If it is cold out, this may be normal. If the smoke does not disappear after the car is warmed, you have a problem. Possible causes:
  1. Transmission fluid may be entering the intake manifold through vacuum modulator.
    The Fix: Replace vacuum modulator
  2. Cylinder head gasket(s) may be bad.
    The Fix: Replace cylinder head gasket(s).
  3. Cylinder head(s) may be warped or cracked.
    The Fix: Resurface or replace cylinder heads. (Resurfacing is not a DIY job)
  4. The engine block may be cracked.
    The Fix: Replace engine block.

Oct 12, 2009 | 2005 Renault R5

1 Answer

Toyota mr2 1991


The catylitic converter is clogged. It needs replaced on it will be fine.

Mar 12, 2009 | 1991 Toyota MR2

3 Answers

My turbo won't boost its starts to shake and pull back


Check out all your air hoses and clamps and check the turbo itself to make sure it spins freely. (Engine not running)

Nov 11, 2008 | 2004 Dodge SRT-4

1 Answer

How do you change the brake lights on a rev1 mark 2 mr2 turbo import?


If the Rear Lights are the bulbs just like the ones in my 91. There should be 3 screws holding the light housings onto the body. You will need a small prybar (preferrably plastic to limit damage), or a Flathead screwdriver.
Open your trunk lid and unscrew the phillips screw that holds the tab of the light on.
The side (outermost) cover should pop off, using from the farthest aft (back) lip, it will require some force, after that is off, it should reveal two smallish phillips screws holding the rest of the housing on.
Once those are removed, the Light housing just pulls off (mild force required, held in by spring type clips)
Then its just finding the right plug (screw and keyway type) to pull off, revealing the bulb itself.

Oct 18, 2008 | 1991 Toyota MR2

1 Answer

Mr2 turbo


Have you changed the fuel filter lately? if not do so, this sounds like a fuel pressure problem.

Oct 16, 2008 | 1994 Toyota MR2

1 Answer

Ford focas turbo disel replacement


either engine has too much oil or turbo bearings gone and it was running on the engine oil being sucked through the turbo.frightening experience and good job you had mind to stall engine before it blew itself up

Jun 30, 2008 | 2001 Ford Focus

Not finding what you are looking for?
2006 Toyota MR2 Spyder Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...