Question about 1992 Mercury Topaz

1 Answer

1992 topaz turns over but wont start

Someone told me it could be a fuel pump. Where is it located and how hard is it to install yourself?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Ok when you turn the key to start it do you hear a high pitch whine for like 1 to 2 seconds if you do it is not your fuel pump. If you do not hear it then you might be correct. I have never changed it but i believe it is under the rear seat not too certain which side. Before you get that far though have you checked any of your battery components or starter? It may be a simple solution
Good Luck

Posted on Aug 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuel filter


The Fuel Filter is located: FUEL FILTER 1992 Mercury Topaz 3.0L FI 6cyl FUEL FILTER 1992 Mercury Topaz 2.3L EFI 4cyl The Fuel Filter is located: Under hood, passenger side, upper engine area, mounted in fuel line The Fuel Filter is located: Under hood, passenger side, upper engine area, mounted in fuel line

May 31, 2012 | 1992 Mercury Topaz

5 Answers

Where is the carburetor on my 93 mercury topaz?


Hi Angela:
First confirm if can you hear the fuel pump when you first key it to the on position. Should hear a hum noise from the rear.

Enclosed is the pinpoint test for your Topaz fuel pump circuit...

11_29_2011_10_32_43_pm.jpg

Also, you will need to check other sensors... the MAF sensor is mounted on your air filter housing and the IAC is located on the throttle body...

11_29_2011_10_34_25_pm.jpg

Zoom Image link: uploads/fordguy4u/2008-05-01_171909_TOPAZ_iac

Additionally, with a 12 volt test light and at the Inertia Switch check for power thru it when you turn the key to the run and crank mode. If its good you should get 12 volts on both side of the connector. Remember that Inertia Switch could cause no power in the fuel pump.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 29, 2011 | 1993 Mercury Topaz

2 Answers

Fuel pump how do I fix the fuel pump?


replace it. it's in the tank. drop the tank.

Sep 17, 2011 | 1989 Mercury Topaz

1 Answer

1992, F250, Diesel, 7.3 International, 4x4, no A/C. Could you please tell me where the fuel pump or fuel pumps are located? This truc has 2 fuel tanks. I have been experiencing starting problems. It seems...


Check rubber return lines running from injectors to back of engine. Hoses maybe cracked and allowing air in the system causing hard long starting.

Jul 21, 2010 | 1992 Ford F250

2 Answers

Where is the fuel pump relay for 92 ford topaz located


Fuel Pump Relay: Locations
The fuel pump relay is an integral part of the Integrated Relay Control Module (IRCM). The IRCM is mounted under the hood, on the driver's strut
tower.

Nov 12, 2009 | 1992 Mercury Topaz

1 Answer

Where is the fuel pump relay located on a 1992 Mercury topaz


the fuel pump relay is located on the left shock tower in the engine compartment in a black box 6x4x1 inches. there are other relays inside the same box which is actually called the ccrm or constant contorl relay module, there should be a double connector with 20 to 26 wires in it, hard to miss.

May 31, 2009 | 1992 Mercury Topaz

2 Answers

93 Mercury topaz does fuel pump have a fuse or relay


there is a fuel pump turn off switch installed on ford. when you lost the tread this was activated. the location will be noted in your owners manual if you have one. usually installed in the rear (trunk area) or front of car drivers side near fuse panel, or passenger side it is a little red button, all you have to do is push it in to reset the switch.

May 06, 2009 | 1992 Mercury Topaz

1 Answer

Fuel pump relay and fuse in a 92 topaz


It's located in the trunk on the drivers side. You should see a black and yellow sticker below a hole indicating that the fuel pump shut off switch is here. Even if your sticker has worn off, if it's a 92 topaz it most likely will be there in that hole. Shine a flashlight in it and you should see a black unit with a red button on top. Push the button down until it clicks in place. If the button is already down, your problem is something else.

Feb 25, 2009 | 1992 Mercury Topaz

2 Answers

92 topaz fuel pump


listen at tank if pump starts when turning key to start car,if yes pump is bad, if no noise check pump fuse ,relay,power at pump

Feb 23, 2009 | 1992 Mercury Topaz

1 Answer

1992 volvo 240 gle wagon


MOST LIKLEY IS THE PUMP WHICH IS LOCATED UNDER VEHICLE DRIVER'S SIDE PASSEENGER SEAT AREA.(IN CHASSIS)
REAR LATCH CAN BE REPLACED

Dec 30, 2008 | 1992 Volvo 240

Not finding what you are looking for?
1992 Mercury Topaz Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...